Part Number: AM623 Hello, I'm referring to PROC124E2A AM62x-LOW POWER SKEVM, which uses MT53E1G16D1FW-046 WT:A LPDDR4. According to datasheet the size of the solderballs should be 0.436mm and PCB board uses 13mils(0.3302mm). Also, if you see the…

Part Number: TDA4VL-Q1 Hello, Can you support in extending CDD IPC app example to run on MCU1_0 communicating with MCU2_0 core ? Regards

Part Number: TDA4AH-Q1 Hello, Can you support in extending CDD IPC app example to run on MCU1_0 communicating with MCU2_0 core ? Regards

Part Number: AM2634 Hi experts, I am using the out-of-box MCAL Eth app demo How do I disable interrupt pacing in my MCAL Ethernet project How do I switch to polling mode instead of interrupt mode.

Part Number: TPS2592AA Other Parts Discussed in Thread: TPS25924 Why is TPS2592AA status changed to NRND (not recommended for new designs) and what is the replacement for it.

Part Number: LP-MSPM0G3507 What Programming Tools are supported for development with MSPM0?

Part Number: BQ25758 Other Parts Discussed in Thread: BQ25756 Hello all, Here is the BQ25756 Schematic and Layout Checklist: BQ25758-Schematic-And-Layout-Checklist.pdf Best Regards, Ethan Galloway

Part Number: AM6442 Hello Sitara team, my customer is working with AM6442 and two Ethernet PHYs ADIN1200 (100Mbit) and ADIN1300 (1Gbit). They would like to use CLKOUT of the AM64 with 25MHz to connect to the 100Mbit PHY. However in the datasheet…

Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?

Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…