FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
When in doubt, use a 0 ohm series resistor on the outputs and adjust accordingly, for your system needs.
This can also…
Part Number: TDA4VM Other Parts Discussed in Thread: SYSCONFIG
Tool/software:
How do we avoid UDMA resource conflict issues when integrating the MCAL Eth module with other modules?
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters >> Current FAQ
The devices do not choose the mode. The mode is based on the devices connected to the TXS / LSF devices.
I.e. These are the two devices that are connected to…
Other Parts Discussed in Thread: TXV0108-Q1 FAQ: Logic and Voltage Translation > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
Data rate depends on the system designers tolerance for various parameters such as VOL / VOH levels, duty cycle distortion…
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
Do not use auto-bidirectional level-shifters if the below is applicable. Use fixed or direction control level-shifters instead…
FAQ: Logic and Voltage Translation > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
[FAQ] Should I use Auto-Bidirectional level-shifters for Fixed directional applications?
[FAQ] Can I estimate Data Rate Frequency not given for my voltage level…
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters >> Current FAQ
[FAQ] Should I use Auto-Bidirectional level-shifters for Fixed directional applications?
[FAQ] How do the LSF translators work?
[FAQ] What is the difference between…