LMK05028EVM: EEPROM default program

Abs

Part Number: LMK05028EVM
Other Parts Discussed in Thread: USB2ANY, LMK05028

Hello

after I re-programmed the EEPROM , I am unable to read or write into the registers anymore , I get and error message telling me <error while writing into register Rxx > or < Error while reading register Rxx>

how can I go back to the default programming of the EEPROM ?

thank you

over 6 years ago

0 Alan O over 6 years ago

TI__Mastermind 32575 points

Try scanning the I2C bus so the USB2ANY controller can set the proper I2C slave address for register write/read accesses.

Alan

0 Abs over 6 years ago in reply to Alan O

Prodigy 50 points

who should I contact to obtain the Excel form for the .tcs file

0 Alan O over 6 years ago in reply to Abs

TI__Mastermind 32575 points

Please see attached.

LMK05028_config_worksheet.xlsx

Regards,
Alan

0 Abs over 6 years ago in reply to Alan O

Prodigy 50 points

LMK05028_config_worksheet-1.xlsxHello Allan

please find attached the Configuration Form filled out

thank you

Abbas hage

0 Alan O over 6 years ago in reply to Abs

TI__Mastermind 32575 points

The TICS Pro software with LMK05028 device profile is available for download.
www.ti.com/.../ticspro-sw

I will review your configuration and generate a TICS Pro setup file (.tcs) for you to try by early next week.

Alan

0 Abs over 6 years ago in reply to Alan O

Prodigy 50 points

Thank you , hope to have it before end of this week

0 Alan O over 6 years ago in reply to Abs

TI__Mastermind 32575 points

Please try the attached .tcs file which you can load in the LMK05028 device profile in TICS Pro.

Regards,
Alan

LMK05028_SeikoEpson_E1_synch_2p048M.tcs

0 Abs over 6 years ago in reply to Alan O

Prodigy 50 points

Hello Allan
I loaded the TCS file you provided, but I am till not able to lock , can you try updating the Config. file so I can try again
note: the board locks with the factory default settings

thank you

0 Alan O over 6 years ago in reply to Abs

TI__Mastermind 32575 points

Hello,

Please try the updated configuration file. I did confirm the previous config file had some incorrect settings that prevented lock.

Thanks for your patience.

Regards,
Alan

LMK05028_SeikoEpson_E1_synch_2p048M_rev1.tcs

Clock & timing

Clock & timing forum

LMK05028EVM: EEPROM default program