TPL5110-Q1: M_DRV_DOH related questions

Henry Chan

Part Number: TPL5110-Q1

Hi Team,

Customer have a few question for TPL5110-Q1

1. If only timing wake-up feature is used, Are they supposed to pull down corresponding voltage on DELAY/M_DRV PIN pin?

2. In the early stage of design, customer wanted to use MCU to control M_DRV_DOH and designed as per datasheet to control MOS.

But in the end they do not want to use this feature, so customer would like to know if it is possible to cancel/remove M_DRV_DOH signal.

3. In datasheet it mentioned that DELAY/M_DRV is briefly pulled VDD, what is the purpose/function of manually turning on the MOS?

To reset counter? if this is the case then is it the same as controlling VDD to disconnect RST_TIMER_DOH?

Thanks

over 1 year ago

0 Noel Fung over 1 year ago

TI__Guru* 85130 points

Hi Henry,

What is _DOH?

DELAY/M_DRV pin needs a pull down resistor to set the time interval, you cannot pull this pin to ground.

If we keep DELAY/M_DRV pin high, then DRV will stay at low until DELAY/M_DRV pin is released.

If we briefly pull this pin to high, DRV cycle will be interrupted, new cycle will start again after some delay. (Figure 7-4 in the datasheet)

0 Henry Chan over 1 year ago in reply to Noel Fung

TI__Prodigy 450 points

Hi Noel,

Thanks for the clarification.

Sorry I failed to attach schematic last time.

For DOH please see below, where customer pull DOH high to disconnect power supply, and use this to reset counter

+1 Noel Fung over 1 year ago in reply to Henry Chan

TI__Guru* 85130 points

Hi Henry,

You can use M_DRV_DOH to reset the counter.

During resistor reading period, the current consumption will be a few hundreds of µA, there will be some voltage drop at R418, this is not a very good design. If you really want to have the option of power supply control, your switch should be placed at VBAT_5V.

Also suggest put a pull-down resistor at DONE pin. D39 made this pin floating.

0 Henry Chan over 1 year ago in reply to Noel Fung

TI__Prodigy 450 points

Got it

thanks you

Clock & timing

Clock & timing forum

TPL5110-Q1: M_DRV_DOH related questions