TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS1298: Full-scale issue 0 Locked

    998 views
    19 replies
    Latest over 5 years ago
    by Alexander Smith
  • Suggested Answer

    ADS8688A: Input impedance when ADC power off 0 Locked

    213 views
    1 reply
    Latest over 5 years ago
    by Dale Li
  • Suggested Answer

    ADC121C021: Wrong I2C address selection inputs 0 Locked

    770 views
    2 replies
    Latest over 5 years ago
    by Nuno Dias
  • Answered

    AMC7834: Bipolar DAC is not clamping to AVss (-5V) 0 Locked

    307 views
    2 replies
    Latest over 5 years ago
    by Marks Greulich
  • Suggested Answer

    LM98620: lm98620 schmatics 0 Locked

    250 views
    2 replies
    Latest over 5 years ago
    by Costin Cazana
  • Answered

    ADS1115: ADS1115 max address support 0 Locked

    1404 views
    4 replies
    Latest over 5 years ago
    by anjali shelke
  • Answered

    ADS1274: Unable to achieve number of Samples per second 0 Locked

    1337 views
    16 replies
    Latest over 5 years ago
    by Barry allen
  • Answered

    AFE4420: How to initialize Tx1,Tx2,Tx3,Tx4 ? 0 Locked

    354 views
    1 reply
    Latest over 5 years ago
    by Praveen Aroul
  • Answered

    ADS1299: ECG amplifiers capable of measuring smaller biopotential signals 0 Locked

    741 views
    12 replies
    Latest over 5 years ago
    by Saba Eas
  • Suggested Answer

    ADS131M08EVM: Compatability check and Validation of Real time capability. 0 Locked

    480 views
    8 replies
    Latest over 5 years ago
    by Joseph Wu
  • Suggested Answer

    ADC128D818: Interrupt behavior 0 Locked

    322 views
    2 replies
    Latest over 5 years ago
    by Joseph Wu
  • Suggested Answer

    ADS131A02: DRDYpin pulse output 0 Locked

    248 views
    1 reply
    Latest over 5 years ago
    by Joseph Wu
  • Not Answered

    DAC5675A: Spurs at DAC output 0 Locked

    1092 views
    3 replies
    Latest over 5 years ago
    by RJ Hopper
  • Not Answered

    DAC088S085: can't make Dout work 0 Locked

    339 views
    3 replies
    Latest over 5 years ago
    by Kevin Duke
  • Not Answered

    DAC8814EVM: DAC8814EVM 0 Locked

    486 views
    4 replies
    Latest over 5 years ago
    by Kevin Duke
  • Answered

    ADC12DJ5200RF: RTM 0 Locked

    181 views
    1 reply
    Latest over 5 years ago
    by Rob Reeder
  • Answered

    DAC60508: Too high noise on DAC outputs of DAC60508 0 Locked

    698 views
    1 reply
    Latest over 5 years ago
    by Paul_Frost
  • Suggested Answer

    ADS1298: RLD derivation and lead-off detection 0 Locked

    1316 views
    2 replies
    Latest over 5 years ago
    by Maciej Lasota
  • Answered

    ADS1274: Compatibility between ADS1274 and C2000 Microprocessors 0 Locked

    338 views
    1 reply
    Latest over 5 years ago
    by Keith Nicholas
  • Suggested Answer

    ADS1675: Modulator Data output mode 0 Locked

    308 views
    2 replies
    Latest over 5 years ago
    by Keith Nicholas
<>