TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    AFE5809EVM: External clock and VCNTL 0 Locked

    323 views
    1 reply
    Latest over 6 years ago
    by Xiaochen (Sean)Xu
  • Suggested Answer

    ADS1158: is AINCOM connected to muxoutn in single ended mode? 0 Locked

    728 views
    7 replies
    Latest over 6 years ago
    by Christopher Hall
  • Answered

    ADS131M04EVM: Unexpected ADC outputs 0 Locked

    471 views
    2 replies
    Latest over 6 years ago
    by Dylan Shuler
  • Suggested Answer

    ADC104S051: ADC104S051 SPI problem on long cables 0 Locked

    518 views
    1 reply
    Latest over 6 years ago
    by Cynthia
  • Suggested Answer

    ADS4449: Inquiry of VCM resister 0 Locked

    390 views
    1 reply
    Latest over 6 years ago
    by jim s
  • Suggested Answer

    Any possible Decoder for RS-343 protocol 0 Locked

    416 views
    1 reply
    Latest over 6 years ago
    by Derek Payne
  • Answered

    DAC38RF82: Providing single ended DACCLK before RSETB togling 0 Locked

    224 views
    1 reply
    Latest over 6 years ago
    by jim s
  • Suggested Answer

    DDC264EVM: Software installation link 0 Locked

    334 views
    3 replies
    Latest over 6 years ago
    by Praveen Aroul
  • Not Answered

    ADS112C04: ads112c04 registers configuration problem 0 Locked

    1102 views
    6 replies
    Latest over 6 years ago
    by Bob Benjamin
  • Suggested Answer

    DAC38RF89: Looking for a process to cover transmitter pre and post cursor EQ settings using EQOVER and EQUNDER 0 Locked

    354 views
    6 replies
    Latest over 6 years ago
    by jim s
  • Answered

    DAC38J84EVM: Once reset DAC, FIFO read empty, but still assert SYNC after SYSREF 0 Locked

    1654 views
    4 replies
    Latest over 6 years ago
    by Yawen Luo
  • Suggested Answer

    CCS/LMP91000: How long is the LMP91000 exiting the DeepSleep mode output voltage stable? 0 Locked

    532 views
    5 replies
    Latest over 6 years ago
    by Ren Schackmann
  • Not Answered

    ADS1232: ADS1232 power down and up reset iss 0 Locked

    678 views
    3 replies
    Latest over 6 years ago
    by Bob Benjamin
  • Answered

    DAC8740H: The reference design of field transmitter with PROFIBUS PA 0 Locked

    559 views
    1 reply
    Latest over 6 years ago
    by Kevin Duke
  • Suggested Answer

    DAC8740H: MCU Source code for FF&PA 0 Locked

    351 views
    1 reply
    Latest over 6 years ago
    by Kevin Duke
  • Not Answered

    ADC12DJ3200EVM: JESD204B Interface with KCU105 0 Locked

    510 views
    1 reply
    Latest over 6 years ago
    by jim s
  • Not Answered

    DAC38RF80EVM: DAC38RF80EVM boards always show abnormalities 0 Locked

    393 views
    1 reply
    Latest over 6 years ago
    by jim s
  • Suggested Answer

    ADC128D818: Voltage present on ADC input signals 0 Locked

    664 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    ADS124S06: Coding Help with ADS124S06 to Arduino Uno 0 Locked

    398 views
    1 reply
    Latest over 6 years ago
    by Bob Benjamin
  • Not Answered

    ADS5400: Differences between revision B and revision C of the ADS5400 0 Locked

    552 views
    6 replies
    Latest over 6 years ago
    by Yusuf%20Agoro
<>