TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADCPRO: ADCPRO doesnt show ADS1278EVM plugin or any plugin 0 Locked

    611 views
    3 replies
    Latest over 6 years ago
    by Keith Nicholas
  • Suggested Answer

    ADS8318: ECCN 0 Locked

    443 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    ADS1118: External pull-up resistance value range 0 Locked

    336 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    ADCPRO: Timeout problem while connecting from ADCPro to ADS1278EVM 0 Locked

    390 views
    1 reply
    Latest over 6 years ago
    by Keith Nicholas
  • Answered

    ADCPRO: ADCPRO download link doesnt work 0 Locked

    443 views
    3 replies
    Latest over 6 years ago
    by Mostafa Koraei
  • Suggested Answer

    DAC7311: Output state concern when low and high level holding time is not enough 0 Locked

    870 views
    5 replies
    Latest over 6 years ago
    by Kevin Duke
  • Answered

    ADS5400-SP: connecting to TSW1400 0 Locked

    614 views
    1 reply
    Latest over 6 years ago
    by Christian Yots
  • Suggested Answer

    DAC8831EVM: DAC8831EVM 0 Locked

    912 views
    11 replies
    Latest over 6 years ago
    by Uttam Sahu
  • Suggested Answer

    TLV5604: one-wire output is out of control. 0 Locked

    760 views
    12 replies
    Latest over 6 years ago
    by Uttam Sahu
  • Answered

    ADS1293: Can We Configure the ADS1293's Sample Rate to 128, 256, 512 and 1024Hz? 0 Locked

    425 views
    2 replies
    Latest over 6 years ago
    by Wayne Chen (Audio AE)
  • Answered

    ADS1292: how to cancel the 50/60Hz noise without RLD lead 0 Locked

    2617 views
    15 replies
    Latest over 6 years ago
    by Alexander Burinskiy
  • Answered

    ADS8688: EXTERNAL CV INPUTS with ADS8688 0 Locked

    2754 views
    10 replies
    Latest over 6 years ago
    by Dale Li
  • Suggested Answer

    ADS1232REF: The ftp-links to the firmware eg. seem to be down 0 Locked

    1258 views
    7 replies
    Latest over 6 years ago
    by Bob Benjamin
  • Suggested Answer

    ADS1298: Detection of Hardware Pace 0 Locked

    1106 views
    3 replies
    Latest over 6 years ago
    by Ryan Andrews
  • Answered

    ADS131E08: Output Code in case of Pseudo-Differential Input 0 Locked

    341 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    ADS1298: Input Common Mode Range 0 Locked

    363 views
    1 reply
    Latest over 6 years ago
    by Ryan Andrews
  • Not Answered

    ADS5401: Suitable Part 0 Locked

    354 views
    1 reply
    Latest over 6 years ago
    by jim s
  • Suggested Answer

    ADS9224R: Full production release date 0 Locked

    374 views
    1 reply
    Latest over 6 years ago
    by Abhijeet Godbole
  • Suggested Answer

    TSW1400EVM: Dealing with the raw adc data of IWR1443 0 Locked

    427 views
    3 replies
    Latest over 6 years ago
    by Alex Rivera
  • Suggested Answer

    CCS/DAC81416: DAC81416 Spi program example 0 Locked

    1385 views
    1 reply
    Latest over 6 years ago
    by Uttam Sahu
<>