TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DAC714: +/-10V Output Voltage Range 0 Locked

    923 views
    1 reply
    Latest over 6 years ago
    by Paul_Frost
  • Suggested Answer

    ADS8638: getting started with EVM 0 Locked

    202 views
    1 reply
    Latest over 6 years ago
    by Tom Hendrick
  • Answered

    ADS1261: internal temperature sensor 0 Locked

    252 views
    1 reply
    Latest over 6 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS8638: schematic for Eval board 0 Locked

    220 views
    1 reply
    Latest over 6 years ago
    by Dale Li
  • Answered

    ADS124S08: INMUX and IDAC Switching Speed 0 Locked

    868 views
    4 replies
    Latest over 6 years ago
    by Jonas Pfaff
  • Answered

    [FAQ] ADC Noise: How do you calculate the noise bandwidth of your system? 0 Locked

    1356 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    [FAQ] ADC Noise: Can clocks affect your ADC’s noise performance? 0 Locked

    1941 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    [FAQ] ADC Noise: How can you reduce the amount of reference noise passing into your system? 0 Locked

    1323 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    [FAQ] ADC Noise: How do you calculate the amount of reference noise passing into your system? 0 Locked

    1277 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    [FAQ] ADC Noise: Is there such a thing as too much gain? 0 Locked

    1234 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    [FAQ] ADC Noise: If you add an external amplifier to the input of an ADC, how does this affect system noise performance? 0 Locked

    1173 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    [FAQ] ADC Noise: What is ENBW and why is it important? 0 Locked

    1826 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    [FAQ] ADC Noise: What is the best noise parameter to use for system noise analysis? 0 Locked

    1243 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    [FAQ] ADC Noise: How is ADC noise measured and specified? 0 Locked

    2849 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    [FAQ] ADC Noise: What types of noise can you expect to find in ADCs? 0 Locked

    1393 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Answered

    TSW1400EVM: MATLAB api error while using the radar studio 0 Locked

    1249 views
    9 replies
    Latest over 6 years ago
    by Anand Gadiyar
  • Suggested Answer

    AFE4300: Regarding BCM Calculation 0 Locked

    803 views
    1 reply
    Latest over 6 years ago
    by Prabin Yadav
  • Answered

    DAC5652A: DAC5652A 0 Locked

    659 views
    7 replies
    Latest over 6 years ago
    by jim s
  • Answered

    [FAQ] How do I reject undesired frequency content by adjusting the clock frequency or oversampling ratio of a Delta-Sigma ADC? 0 Locked

    1279 views
    1 reply
    Latest over 6 years ago
    by Joachim Wuerker
  • Answered

    [FAQ] How does the digital filter frequency response of a Delta-Sigma ADC scale with clock frequency? 0 Locked

    2072 views
    1 reply
    Latest over 6 years ago
    by Joachim Wuerker
<>