TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS1158: ADC1158 occasional configuration/SPI communication failure; no activity on MISO signal from ADC 0 Locked

    361 views
    1 reply
    Latest over 7 years ago
    by Christopher Hall
  • Answered

    ADS1292ECG-FE: Problem debugging the communication of ADS1292 0 Locked

    683 views
    4 replies
    Latest over 7 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS1198: LibUSB0.dll not found issue, also unable to access TI FTP for driver downloads 0 Locked

    890 views
    3 replies
    Latest over 7 years ago
    by Alexander Smith
  • Suggested Answer

    Looking for information about MIC2/C 0 Locked

    2623 views
    3 replies
    Latest over 7 years ago
    by LeonardEllis
  • Not Answered

    ADS7953: Configuring Internal Reference Voltage to (5 volts) 0 Locked

    326 views
    1 reply
    Latest over 7 years ago
    by Sandeep Kasargod
  • Suggested Answer

    HDMI Recorder Module 0 Locked

    432 views
    4 replies
    Latest over 7 years ago
    by Pooja Mahajan
  • Answered

    ADS1281: Some questions about Sync timing 0 Locked

    552 views
    2 replies
    Latest over 7 years ago
    by NAOKI AOYAMA
  • Answered

    ADS1262: 1 mV Absolute Accuracy over 5V FSR without calibration. Problems with absolute accuracy. 0 Locked

    1639 views
    3 replies
    Latest over 7 years ago
    by Christopher Hall
  • Answered

    ADS112C04: Read Conversion Data Sequence (Sec 8.5.3.5) questions 0 Locked

    826 views
    4 replies
    Latest over 7 years ago
    by Sarvesh Patkar20
  • Not Answered

    ADS7843: Conflict of SPI and PENIRQ 0 Locked

    777 views
    1 reply
    Latest over 7 years ago
    by Cynthia
  • Suggested Answer

    LDC1612: touch panel implementation on glass 0 Locked

    334 views
    1 reply
    Latest over 7 years ago
    by Kristin Jones93
  • Suggested Answer

    FDC1004: Environmental change 0 Locked

    522 views
    1 reply
    Latest over 7 years ago
    by Kristin Jones93
  • Answered

    PGA411Q1EVM: Input current of PGA411-Q1 EVM to high 0 Locked

    1053 views
    4 replies
    Latest over 7 years ago
    by Clancy Soehren
  • Suggested Answer

    ADS1298: Configure ADS1298 for 1 channel ECG 0 Locked

    2168 views
    5 replies
    Latest over 7 years ago
    by Alexander Smith
  • Suggested Answer

    Sourcing Current Monitor solution 0 Locked

    518 views
    1 reply
    Latest over 7 years ago
    by Patrick Simmons
  • Answered

    LDC2114: Threshold value for on detection 0 Locked

    414 views
    4 replies
    Latest over 7 years ago
    by Steve Roe
  • Answered

    ADC12J1600EVM: ADC12J1600EVM connection issue 0 Locked

    1100 views
    2 replies
    Latest over 7 years ago
    by Mahesh K C47
  • Answered

    LM98640CVAL: DLL False lock & serial interface problems 0 Locked

    1385 views
    6 replies
    Latest over 7 years ago
    by Kirby Kruckmeyer96848
  • Suggested Answer

    DAC084S085: DAC084S085 full scale output 0 Locked

    355 views
    1 reply
    Latest over 7 years ago
    by Paul_Frost
  • Suggested Answer

    ADS1292: Convert ADC Code to voltage 0 Locked

    2931 views
    14 replies
    Latest over 7 years ago
    by Alexander Smith
<>