TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    FDC1004: Which package is in come use ? 0 Locked

    459 views
    3 replies
    Latest over 7 years ago
    by Kristin Jones93
  • Answered

    ADS131E08: CONFIG4 register use 0 Locked

    286 views
    1 reply
    Latest over 7 years ago
    by Alexander Smith
  • Answered

    ADS8330: SCLK TAG bit, and SDI signal 1101 0 Locked

    1152 views
    7 replies
    Latest over 7 years ago
    by Keith Nicholas
  • Not Answered

    ADS7882: ADS7882 0 Locked

    656 views
    1 reply
    Latest over 7 years ago
    by Dale Li
  • Suggested Answer

    AMC1305M05: Sinc3_16 and ripple wave relation ship 0 Locked

    839 views
    3 replies
    Latest over 7 years ago
    by Alexander Smith
  • Answered

    DAC3484EVM: maximum data transfer speed TSW1400EVM -> DAC3484EVM 0 Locked

    483 views
    1 reply
    Latest over 7 years ago
    by Kang Hsia
  • Answered

    ADS7862: Newer replacement? 0 Locked

    416 views
    2 replies
    Latest over 7 years ago
    by Needhu Gunasegaran
  • Answered

    ADS4222: ADC that is compatible with Simultaneous Sampling 0 Locked

    656 views
    3 replies
    Latest over 7 years ago
    by jim s
  • Answered

    TSW14J56EVM: trigger capability and TSW14xx synchronization 0 Locked

    1369 views
    6 replies
    Latest over 7 years ago
    by jim s
  • Answered

    Problems of reading with LMP 90100 0 Locked

    679 views
    2 replies
    Latest over 7 years ago
    by Alexander Morkovin
  • Answered

    ADS54J20EVM: common mode voltage and sampling frequency range with 10MHz reference 0 Locked

    529 views
    3 replies
    Latest over 7 years ago
    by Majid Boloorian
  • Not Answered

    ADS7830: Internal reference, 0,1uF capacitor missing 0 Locked

    511 views
    1 reply
    Latest over 7 years ago
    by Abhijeet Godbole
  • Suggested Answer

    AFE4300: reference designs for body composition meter 0 Locked

    396 views
    1 reply
    Latest over 7 years ago
    by Prabin Yadav
  • Answered

    FDC2214EVM: FDC2214EVM is recognized as FDC2114EVM when plugging into computer and communicating with GUI 0 Locked

    783 views
    5 replies
    Latest over 7 years ago
    by Kristin Jones93
  • Answered

    ADS1232REF: How to attain Voltage via serial console? 0 Locked

    424 views
    2 replies
    Latest over 7 years ago
    by user5775227
  • Answered

    DAC38RF82EVM: TSW14J56EVM How to configure for CMODE1, Dual(12bits), max. rate (3.333GHz)? 0 Locked

    508 views
    1 reply
    Latest over 7 years ago
    by Ebenezer Dwobeng
  • Answered

    ADS52J90EVM: ADS52J90 EVM external reference voltage 0 Locked

    675 views
    4 replies
    Latest over 7 years ago
    by Praveen Aroul
  • Answered

    DDC11XEVM-PDK: Hardware trigger 0 Locked

    404 views
    1 reply
    Latest over 7 years ago
    by Praveen Aroul
  • Answered

    ADS1231: Delta sigma ADC for loadcell bridge application 0 Locked

    1026 views
    5 replies
    Latest over 7 years ago
    by Bob Benjamin
  • Suggested Answer

    ADS1232: ADS1232 0 Locked

    606 views
    1 reply
    Latest over 7 years ago
    by Bob Benjamin
<>