TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS8528: Data disordered when applied in voltage&current sensing 0 Locked

    1328 views
    3 replies
    Latest over 7 years ago
    by Dale Li
  • Suggested Answer

    TINA/Spice/DAC34H84: dac34h84 model 0 Locked

    565 views
    1 reply
    Latest over 7 years ago
    by Kang Hsia
  • Answered

    DAC3164: IO Test Clarification 0 Locked

    1439 views
    8 replies
    Latest over 7 years ago
    by dBrock
  • Suggested Answer

    ADS131E08S: Sample missing 0 Locked

    1203 views
    5 replies
    Latest over 7 years ago
    by Tom Hendrick
  • Answered

    AMC1303M2510: Output CLK frequency 0 Locked

    1002 views
    5 replies
    Latest over 7 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS1298RECGFE-PDK: ads1298 EVM respiration inquiry 0 Locked

    2229 views
    6 replies
    Latest over 7 years ago
    by Hayden Shin
  • Answered

    ADS8881EVMV2-PDK: SNR has a huge gap between tested result and datasheet 0 Locked

    1046 views
    3 replies
    Latest over 7 years ago
    by Lucas Ding
  • Not Answered

    TSW40RF80EVM: Request Configuration File 0 Locked

    1292 views
    7 replies
    Latest over 7 years ago
    by Louis Han15
  • Not Answered

    PGA411-Q1: VCC and VIO load current question 0 Locked

    1206 views
    5 replies
    Latest over 7 years ago
    by Clancy Soehren
  • Suggested Answer

    ADC128D818: Detailed informations about internal reference block of ADC128D818 are needed. 0 Locked

    1010 views
    4 replies
    Latest over 7 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS131A04: Driving 3 devices with the same clock source 0 Locked

    514 views
    1 reply
    Latest over 7 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS124S08: What's the condition of the RTD Circuit Design Parameters in datasheet 0 Locked

    677 views
    1 reply
    Latest over 7 years ago
    by Joseph Wu
  • Answered

    ADS42JB69EVM: I need the orcad schematic instead of a PDF file. 0 Locked

    1522 views
    7 replies
    Latest over 7 years ago
    by Jim Brinkhurst1
  • Answered

    ADC12DJ3200EVM: EVM Configuration settings required to view the I&Q waveforms 0 Locked

    612 views
    3 replies
    Latest over 7 years ago
    by Richard Elmquist
  • Suggested Answer

    ADC12D1600RF: ADC12D1600RF Frequency 0 Locked

    676 views
    2 replies
    Latest over 7 years ago
    by Jim Brinkhurst1
  • Not Answered

    There is a mistake in DAC7821's DATASHEET? 0 Locked

    547 views
    1 reply
    Latest over 7 years ago
    by Kevin Duke
  • Suggested Answer

    AFE4300: Calculation of BIS implementation using IQ mode 0 Locked

    669 views
    1 reply
    Latest over 7 years ago
    by Prabin Yadav
  • Suggested Answer

    DAC38RF80: DAC38RF80 SPI Register Check? 0 Locked

    527 views
    2 replies
    Latest over 7 years ago
    by Kang Hsia
  • Suggested Answer

    AFE4300: Open-source/commercialization of AFE4300 0 Locked

    863 views
    1 reply
    Latest over 7 years ago
    by Prabin Yadav
  • Not Answered

    ADS54J42: ADS54J42 SPI? 0 Locked

    396 views
    1 reply
    Latest over 7 years ago
    by jim s
<>