TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS1262: AVDD Voltage Level 0 Locked

    1044 views
    3 replies
    Latest over 7 years ago
    by Christopher Hall
  • Not Answered

    ADC32RF42EVM: ADC32RF42EVM HSDC Pro configuration File ADC32RF42_LMF_42810.ini. 0 Locked

    910 views
    2 replies
    Latest over 7 years ago
    by Jagadeesh Viswanathan46
  • Not Answered

    ADS1298RECGFE-PDK: ADS1298RECGFE problem 0 Locked

    550 views
    1 reply
    Latest over 7 years ago
    by Ryan Andrews
  • Suggested Answer

    Starterware/DAC8560EVM-PDK: 64bit DXP driver missing? 0 Locked

    752 views
    1 reply
    Latest over 7 years ago
    by Matthew Sauceda
  • Answered

    ADS52J90: Question of JESD_RESET1 0 Locked

    1324 views
    7 replies
    Latest over 7 years ago
    by Olu Sodipe
  • Suggested Answer

    ADS1120: POR 0 Locked

    817 views
    3 replies
    Latest over 7 years ago
    by Bob Benjamin
  • Not Answered

    ADS52J90EVM: Can I get a PCB Data(Gerber) for ads52j90evm? 0 Locked

    460 views
    1 reply
    Latest over 7 years ago
    by Olu Sodipe
  • Suggested Answer

    ADS1292: What happens if unused analog inputs float? Why the recommendation to tie them to VDD? 0 Locked

    1060 views
    1 reply
    Latest over 7 years ago
    by Ryan Andrews
  • Suggested Answer

    ADC12DJ3200EVM: Configuration GUI is not able to connect the ADC12DJ3200EVM after replacing a new FT4232H 0 Locked

    610 views
    1 reply
    Latest over 7 years ago
    by Jim Brinkhurst1
  • Answered

    ADS54J54: Polarity of SYNCb pins when it starts transmitting K28.5 character 0 Locked

    568 views
    2 replies
    Latest over 7 years ago
    by Hiroshi Katsunaga
  • Answered

    ADS54J54: How to configure for unused SYNCbCDP/M pins 0 Locked

    474 views
    2 replies
    Latest over 7 years ago
    by Hiroshi Katsunaga
  • Suggested Answer

    AMC1305M05: Eagle CAD packages 0 Locked

    825 views
    3 replies
    Latest over 7 years ago
    by Tom Hendrick
  • Not Answered

    ADS1248: device recommendation 0 Locked

    379 views
    1 reply
    Latest over 7 years ago
    by Joachim Wuerker
  • Answered

    ADS54J54: Code Group Synchronization 0 Locked

    608 views
    2 replies
    Latest over 7 years ago
    by Hiroshi Katsunaga
  • Answered

    DAC7612: DAC7612 - Output pin state at start up (Hi-Z?) 0 Locked

    696 views
    2 replies
    Latest over 7 years ago
    by Takeshi Sasaki
  • Answered

    ADS127L01EVM: Core application GUI can’t identify ADS127L01 device 0 Locked

    665 views
    2 replies
    Latest over 7 years ago
    by trout
  • Answered

    ADS8556: Exposed Thermal Pad 0 Locked

    662 views
    2 replies
    Latest over 7 years ago
    by Hiroshi Takahashi
  • Suggested Answer

    ADS6425: Looking for 12 bit ADC with a clock associated with each channel 0 Locked

    472 views
    1 reply
    Latest over 7 years ago
    by high speed guy
  • Not Answered

    PGA309: Design for Weigh Scale 0 Locked

    940 views
    2 replies
    Latest over 7 years ago
    by Alex Davis
  • Answered

    ADS1291: precisely what is missing compared to the 1292? 0 Locked

    945 views
    3 replies
    Latest over 7 years ago
    by Ryan Andrews
<>