TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS7253 Reference 0 Locked

    394 views
    2 replies
    Latest over 9 years ago
    by cafain
  • Answered

    Password for ADS1299EVM.zip 0 Locked

    293 views
    1 reply
    Latest over 9 years ago
    by Ryan Andrews
  • Answered

    ADS1248EVM / AIN0 read value 0 Locked

    312 views
    1 reply
    Latest over 9 years ago
    by Joseph Wu
  • Not Answered

    Help converting WVGA to HDMI 0 Locked

    629 views
    1 reply
    Latest over 9 years ago
    by Steve Clynes
  • Not Answered

    IC for analog A-weight filter? 0 Locked

    304 views
    0 replies
    Started over 9 years ago
    by Jarrod Zacher
  • Answered

    Can I interleave or sequence 100Msps ADCs to achieve Gsps sampling rate 0 Locked

    643 views
    5 replies
    Latest over 9 years ago
    by Aditya Vighnesh Ramakanth Bommireddipalli
  • Answered

    ADS1263 32-bit A/D converter noise floor 0 Locked

    1701 views
    12 replies
    Latest over 9 years ago
    by Christopher Hall
  • Not Answered

    DAC3171 configuration problem 0 Locked

    2082 views
    11 replies
    Latest over 9 years ago
    by Philipp Burch
  • Not Answered

    ADC12J4000 crashing after external mod 0 Locked

    164 views
    1 reply
    Latest over 9 years ago
    by Jim Brinkhurst1
  • Not Answered

    DDC264EVM, analog breadboarding 0 Locked

    380 views
    1 reply
    Latest over 9 years ago
    by Adam Sidelsky
  • Suggested Answer

    DAC5688 spurs problem 0 Locked

    435 views
    3 replies
    Latest over 9 years ago
    by Neeraj Gill
  • Not Answered

    ADS5400 Overrange Bit TEST Pattern 0 Locked

    318 views
    2 replies
    Latest over 9 years ago
    by Steven Mendez
  • Not Answered

    IN AFE4490 EVM's GUI ADC capture and analyses throws error after clicking capture as " Insufficient number of samples for FFT calculation " 0 Locked

    387 views
    1 reply
    Latest over 9 years ago
    by Amy Schnoor
  • Not Answered

    https://e2e.ti.com/support/applications/high_reliability/f/30/t/488404 0 Locked

    272 views
    1 reply
    Latest over 9 years ago
    by Amy Schnoor
  • Answered

    ADS8688 - the method of data output(using Manual Channel n Select) and reset command 0 Locked

    1336 views
    6 replies
    Latest over 9 years ago
    by Dale Li
  • Not Answered

    ADS 5474 Spurious-free dynamic range 0 Locked

    466 views
    2 replies
    Latest over 9 years ago
    by Richard Prentice
  • Not Answered

    AFE4400 EVM capture error 0 Locked

    1134 views
    4 replies
    Latest over 9 years ago
    by Parth Modi68
  • Answered

    AFE7225 DAC, ADC 0 Locked

    885 views
    2 replies
    Latest over 9 years ago
    by KW Nam
  • Answered

    TLC3578 A7 Channel Offset 0 Locked

    655 views
    1 reply
    Latest over 9 years ago
    by Luis Chioye
  • Suggested Answer

    TSW308x EVM Software (Rev. B) 0 Locked

    305 views
    3 replies
    Latest over 9 years ago
    by Kang Hsia
<>