TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    board adapter 0 Locked

    275 views
    0 replies
    Started over 10 years ago
    by Marcelo Antonio Marquez
  • Answered

    ADS131E06 0 Locked

    252 views
    1 reply
    Latest over 10 years ago
    by Greg Hupp
  • Not Answered

    AFE4490 GUI can not detect the board when downloading the firmware. But USB is ready. 0 Locked

    372 views
    2 replies
    Latest over 10 years ago
    by Amy Schnoor
  • Suggested Answer

    ADS131E08: different behaviour between 2 kind of chip 0 Locked

    510 views
    2 replies
    Latest over 10 years ago
    by Greg Hupp
  • Answered

    Safety of the ADS1292r 0 Locked

    528 views
    5 replies
    Latest over 10 years ago
    by Brian Pisani
  • Not Answered

    AFE4490 seems to go to saturation @ ~35mV? 0 Locked

    848 views
    5 replies
    Latest over 10 years ago
    by user138497234
  • Not Answered

    DDC114 Capacity Range Problems 0 Locked

    425 views
    2 replies
    Latest over 10 years ago
    by Adam Sidelsky
  • Not Answered

    ads4229 altium component (or ultralibrarian) 0 Locked

    436 views
    1 reply
    Latest over 10 years ago
    by jim s
  • Answered

    ADS1198 Chest Electrode output is missing 0 Locked

    1080 views
    11 replies
    Latest over 10 years ago
    by Brian Pisani
  • Not Answered

    Two outputs ADS62P45 imbalance 0 Locked

    400 views
    1 reply
    Latest over 10 years ago
    by jim s
  • Not Answered

    VCA2615 Rin formula on page 18 of the data sheet 0 Locked

    398 views
    2 replies
    Latest over 10 years ago
    by Mark Wolf
  • Answered

    ADS1299EEG-FE Sampling/Timing 0 Locked

    276 views
    1 reply
    Latest over 10 years ago
    by Brian Pisani
  • Suggested Answer

    Selecting suitable adc >100ksps 0 Locked

    334 views
    1 reply
    Latest over 10 years ago
    by Joseph Wu
  • Not Answered

    ADS42JB69EVM LMF=222 configuration 0 Locked

    555 views
    1 reply
    Latest over 10 years ago
    by Ebenezer Dwobeng
  • Answered

    ADS5401 interleaved ADCs 0 Locked

    437 views
    1 reply
    Latest over 10 years ago
    by Richard Prentice
  • Not Answered

    TSC2013 Knowledge 0 Locked

    3953 views
    10 replies
    Latest over 10 years ago
    by Andy Liu (BMS)
  • Not Answered

    ADS1274 - large distortion appear in the converted data, analog input is fine 0 Locked

    328 views
    1 reply
    Latest over 10 years ago
    by Ryan Andrews
  • Answered

    New 1292 Design software questions 0 Locked

    1682 views
    16 replies
    Latest over 10 years ago
    by Brian Pisani
  • Answered

    DAC5681EVM with TSW1400EVM 0 Locked

    2289 views
    19 replies
    Latest over 10 years ago
    by jim s
  • Answered

    Bit CLP mode enable for LM98725 0 Locked

    925 views
    2 replies
    Latest over 10 years ago
    by Elnur Babishov
<>