TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    help for -> major area of digital video into several sub-divided parts. 0 Locked

    414 views
    3 replies
    Latest over 14 years ago
    by Larry Taylor
  • Discussion

    Right Leg Driver RLDINV can that be also made into a shield driver for electrode cables? A few articles show a shield driver would be helpful would that be the correct pin to do it with a 100 ohm and 10k resistor and would a 1k resistor need to go between Locked

    461 views
    2 replies
    Latest over 14 years ago
    by josh wojnas
  • Discussion

    Interfacing ADS8556 with 320TMS6713 Locked

    869 views
    6 replies
    Latest over 14 years ago
    by rohith mohan
  • Answered

    Accuracy of the IDAC 0 Locked

    332 views
    1 reply
    Latest over 14 years ago
    by Bob Benjamin
  • Not Answered

    What's the functions of these registers and what's wrong with my board? 0 Locked

    245 views
    2 replies
    Latest over 14 years ago
    by Larry Taylor
  • Answered

    1298 connections 0 Locked

    450 views
    5 replies
    Latest over 14 years ago
    by Tom Hendrick
  • Answered

    ads5463 heat issue and differential input biasing 0 Locked

    352 views
    2 replies
    Latest over 14 years ago
    by Matthew McCullough
  • Answered

    ADS1298 0 Locked

    437 views
    3 replies
    Latest over 14 years ago
    by Tom Hendrick
  • Answered

    input configuration using Back to back Balun shown in evaluation module of ADS5474 0 Locked

    1096 views
    5 replies
    Latest over 14 years ago
    by Bhupesh Patil
  • Answered

    ADS5474 Evaluation Board 0 Locked

    692 views
    2 replies
    Latest over 14 years ago
    by Frank Cardone
  • Answered

    ADS1298 for EMG recording 0 Locked

    2292 views
    3 replies
    Latest over 14 years ago
    by Michael W
  • Answered

    ADS8412EVM 0 Locked

    719 views
    9 replies
    Latest over 14 years ago
    by Tom Hendrick
  • Answered

    Offset Errors and Resolution for Delta-Sigma ADC (16-bit ADS1110) 0 Locked

    1680 views
    4 replies
    Latest over 14 years ago
    by Leon Rasberry
  • Discussion

    Maximum number of samples in ADCpro? Locked

    249 views
    1 reply
    Latest over 14 years ago
    by Greg Hupp
  • Answered

    how to open two ports(portA+portB) of dm6467 for tvp5158? 0 Locked

    776 views
    6 replies
    Latest over 14 years ago
    by yong wu58344
  • Answered

    DAC5688 power consumption graph 0 Locked

    431 views
    8 replies
    Latest over 14 years ago
    by Kang Hsia
  • Answered

    DM368 encode 1080i 0 Locked

    426 views
    1 reply
    Latest over 14 years ago
    by Larry Taylor
  • Answered

    ADS1232REF - New Beginner 0 Locked

    574 views
    8 replies
    Latest over 14 years ago
    by Bob Benjamin
  • Answered

    THS8135: Signal Anomoly Question 0 Locked

    298 views
    1 reply
    Latest over 14 years ago
    by Larry Taylor
  • Answered

    DDC BGA 0 Locked

    297 views
    1 reply
    Latest over 14 years ago
    by Jason Bridgmon
<>