TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    Data acquisition in the 500MHz range for decay time measurements 0 Locked

    707 views
    5 replies
    Latest over 15 years ago
    by RJ Hopper
  • Answered

    ADS1258 unipolar use 0 Locked

    571 views
    4 replies
    Latest over 15 years ago
    by Gary To
  • Answered

    Anyone notice AGND/DGND went away on the latest datasheet for the ADS5463-EP (Oct 2009)? Any ideas what this means? 0 Locked

    445 views
    2 replies
    Latest over 15 years ago
    by Hui-Qing Liu
  • Answered

    ads1255(56) input range during system gain calibration 0 Locked

    498 views
    2 replies
    Latest over 15 years ago
    by Oleg Voitovich
  • Answered

    ADS1248 input pins protection 0 Locked

    357 views
    1 reply
    Latest over 15 years ago
    by Joseph Wu
  • Answered

    ADS8412 timing characteristics question 0 Locked

    502 views
    1 reply
    Latest over 15 years ago
    by Tony Calabria
  • Discussion

    DAC5682z configuration Locked

    265 views
    1 reply
    Latest over 15 years ago
    by Ruben
  • Answered

    Understanding the passive termination for current output DACs 0 Locked

    653 views
    1 reply
    Latest over 15 years ago
    by Hamza Fraz
  • Answered

    ADS1278EVM-PDK MMB0 - ADCPro Plugin Question 0 Locked

    1649 views
    5 replies
    Latest over 15 years ago
    by T Tran
  • Answered

    ADS79xx: Unexpected binary output for midscale voltage input 0 Locked

    603 views
    5 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    Cabling and Signal Conditioning for serial PCB connections 0 Locked

    646 views
    4 replies
    Latest over 15 years ago
    by Brian Willoughby
  • Answered

    ADS1241 A/D Converter "Full Scale Resolution" Question 0 Locked

    666 views
    5 replies
    Latest over 15 years ago
    by Rick Downs - WEBENCH Design Center
  • Answered

    ADS1178 returns constant zeroes 0 Locked

    538 views
    8 replies
    Latest over 15 years ago
    by RUBBI
  • Answered

    DCP for the connection between TMS320C6416T and ADS1256EVM 0 Locked

    705 views
    6 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    ADS8361 data syncronisation problem in Mode II 0 Locked

    1324 views
    8 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    ADS 8330 interface problem 0 Locked

    2172 views
    10 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    ADS1258 wrong ID code 0 Locked

    453 views
    1 reply
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    ADS1243 init and operation command sequence question 0 Locked

    534 views
    2 replies
    Latest over 15 years ago
    by Joseph Wu
  • Answered

    ADS8342 running hot when supplied with -5V 0 Locked

    510 views
    4 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    ADS1243 Supply, muxed reference and SPI voltage levels design problems 0 Locked

    1649 views
    10 replies
    Latest over 15 years ago
    by fbj
<>