TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    AFE10004EVM: Python 2.7 not detected when using AFE10004EVM SW 0 Locked

    373 views
    1 reply
    Latest over 3 years ago
    by Paul_Frost
  • Suggested Answer

    ADC12DJ3200: JMODE 0 Data Capture 0 Locked

    747 views
    9 replies
    Latest over 3 years ago
    by Ameet Bagwe
  • Suggested Answer

    TLC7226: Analog Voltage not set as per requirement 0 Locked

    597 views
    11 replies
    Latest over 3 years ago
    by Lucas Burnette
  • Not Answered

    AFE44I30: Calibration for the Automatic LED DC Cancellation 0 Locked

    470 views
    5 replies
    Latest over 3 years ago
    by Nick Zahabizadeh
  • Answered

    ADS1278: ADS1278 voltage reference input current 0 Locked

    218 views
    1 reply
    Latest over 3 years ago
    by Keith Nicholas
  • Answered

    ADS1602: ADS1602 SNR test software 0 Locked

    321 views
    1 reply
    Latest over 3 years ago
    by Dale Li
  • Suggested Answer

    ADS5294: LCLK and ACLK phase alignment problem 0 Locked

    184 views
    1 reply
    Latest over 3 years ago
    by Karthik Nagabhushana
  • Answered

    ADS127L01: can not read registers through SPI 0 Locked

    457 views
    6 replies
    Latest over 3 years ago
    by kim park
  • Answered

    ADS7028: Once again another TI part with no source code support 0 Locked

    431 views
    2 replies
    Latest over 3 years ago
    by James Parisi
  • Answered

    ADS7028: ADC with RMS module 0 Locked

    238 views
    1 reply
    Latest over 3 years ago
    by Tom Hendrick
  • Answered

    ADS1278-EP: SPI Data output is Not Consistency for all 8 channels. 0 Locked

    515 views
    4 replies
    Latest over 3 years ago
    by Venugopal B
  • Not Answered

    TMDSEVM6678: SPI bus contention problem 0 Locked

    203 views
    0 replies
    Started over 3 years ago
    by Zhen He
  • Answered

    ADC12J4000: Low phase noise clocking solution 0 Locked

    320 views
    2 replies
    Latest over 3 years ago
    by Jennifer Bernal
  • Answered

    ADS7067: 0 Locked

    359 views
    4 replies
    Latest over 3 years ago
    by Behnam Behroozpour
  • Suggested Answer

    ADS1601: Is there EVM or reference design of ADS1601 chip? 0 Locked

    469 views
    4 replies
    Latest over 3 years ago
    by Ryan Andrews
  • Answered

    ADS42JB46EVM: Inverted SYNC~ Polarity? 0 Locked

    438 views
    4 replies
    Latest over 3 years ago
    by Chase W
  • Answered

    DAC8734: EVM - DAC A-GROUP output negatively biased. User ZERO Calibration won't help 0 Locked

    567 views
    11 replies
    Latest over 3 years ago
    by Stefano Alfredo La Spina
  • Suggested Answer

    ADS1118-Q1: How to deal with unused ADC channels 0 Locked

    234 views
    1 reply
    Latest over 3 years ago
    by Cole Macias
  • Answered

    DAC70501: DAC-DATA 0 Locked

    361 views
    9 replies
    Latest over 3 years ago
    by Paul_Frost
  • Suggested Answer

    ADS1246: PGA set to 1 but readings are 4 times to high 0 Locked

    438 views
    8 replies
    Latest over 3 years ago
    by Bryan Lizon86
<>