TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DP83869HM: Bridge Mode Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] UART Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page UART Protection Highlights: Lower speed serial data transfer interface Operating lines: GND, ±TX, ±RX Datalines (±Tx, ±Rx) Operating voltage: 3.3V, recommended Vbr > 3.6V Data rates up to 5Mbps TI…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    TPS65983B: TPS65983B FW config tool and total relational data 0 Locked

    469 views
    3 replies
    Latest over 7 years ago
    by Eric Beljaars
  • Suggested Answer

    PCA9554A: pca9554A 0 Locked

    553 views
    1 reply
    Latest over 7 years ago
    by Miguel Robertson
  • Suggested Answer

    HD3SS3220: schematic 0 Locked

    308 views
    2 replies
    Latest over 7 years ago
    by David Zhao
  • Answered

    TPS25740: TPS25740 Adapter can not chanrge NOTEBOOK when the NOTEBOOK is power off 0 Locked

    2624 views
    15 replies
    Latest over 7 years ago
    by Huazi
  • Answered

    UCC21520: Parallel MOSFET drive with using UCC21520 , what is the maximum Bootstrap capacitor to use 0 Locked

    896 views
    5 replies
    Latest over 7 years ago
    by Mamadou Diallo
  • Answered

    DS25CP104A: Does DS25CP104A support pathological and Check Field video pattern ? 0 Locked

    1088 views
    4 replies
    Latest over 7 years ago
    by Kawai
  • Answered

    Protection for Earphone/Microphone 0 Locked

    549 views
    2 replies
    Latest over 7 years ago
    by Takayuki Miyazaki
  • Answered

    TPS65982: Memory Address for High region 0 Locked

    320 views
    2 replies
    Latest over 7 years ago
    by Takashi Onawa
  • Suggested Answer

    TCAN1043-Q1: Difference between TCAN1043-Q1 and TCAN1042-Q1 0 Locked

    1128 views
    1 reply
    Latest over 7 years ago
    by Adrian Ymeraj
  • Answered

    SN65LVDT390: LVDS Signals Present with Receiver Powered Down 0 Locked

    394 views
    1 reply
    Latest over 7 years ago
    by Yaser Ibrahim
  • Answered

    Which is the simplest UFP PD controller? 0 Locked

    807 views
    7 replies
    Latest over 7 years ago
    by Eric Beljaars
  • Answered

    DP83867ERGZ-S-EVM: IO Voltage & Start-up Sequence 0 Locked

    663 views
    3 replies
    Latest over 7 years ago
    by Rob Rodrigues
  • Suggested Answer

    TLK10232: TLK10232CTR 0 Locked

    349 views
    1 reply
    Latest over 7 years ago
    by Luis Omar Moran
  • Answered

    SN65DSI85: Stream one DSI video signal to two signle link LVDS displays 0 Locked

    516 views
    1 reply
    Latest over 7 years ago
    by Joel Jimenez0
  • Suggested Answer

    DP83867E: No communication established when connected to a 1Gbps capable end device 0 Locked

    511 views
    1 reply
    Latest over 7 years ago
    by Aniruddha Khadye
  • Suggested Answer

    DP83867IRPAP-EVM: export control coverage 0 Locked

    394 views
    1 reply
    Latest over 7 years ago
    by Aniruddha Khadye
  • Suggested Answer

    ISO3082: Isolated RS-485 with TTL output 0 Locked

    1260 views
    3 replies
    Latest over 7 years ago
    by Dan Kisling
  • Answered

    HD3SS3220: HD3SS3220 0 Locked

    375 views
    1 reply
    Latest over 7 years ago
    by Luis Omar Moran
  • Answered

    DS90C3201: Replacing DS90C387A for DVI to LVDS conversion with SSC. 0 Locked

    1609 views
    8 replies
    Latest over 7 years ago
    by Darryl Jeong
  • Answered

    TSB81BA3E: Interoperability with TSB41BA3 0 Locked

    1001 views
    5 replies
    Latest over 7 years ago
    by Go Bravos
<>