TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS280DF810: Can I use a signal conditioning device at a lower data rate than its target application?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS160PR410 , A common question when using a signal conditioning device is can the device support a data rate that is lower than the target data rate. The answer to this is device dependent, but…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Debug procedure if TI TUSB80xx or TUSB40xx hub can not be detected by USB host

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A 1: Check power on reset sequence waveform for 3.3v ,1/1v and GRSTz pin and see if it meets hub power on reset sequence timing 2: Check voltage on USB_VBUS pin and see if the voltage is around 0.5v 3: Check if the crystal is…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TMUXHS4212: When and how to AC coupling the passive MUX?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: TMUXHS4212 When and how do I place the AC coupling capacitors for the passive MUX?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Does redriver power consumption vary with data rate?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Other Parts Discussed in Thread: DS160PR421 , DS160PR1601 , DS160PR410 , DS160PR810 , DS160PR412 , , DS320PR1601 , DS320PR410 , SN75LVPE5412 , SN75LVPE5421 Applicable to all TI PCIe redrivers for Gen 4: DS160PR410, DS160PR810…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Difference between TUSB804x USB3 hub family

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 , , TUSB8042A , TUSB8043A , TUSB8044A Over the time, TI TUSB804x USB3 hub family has been transitioned from USB3.0 to USB3.1, from TUSB8041 to TUSB8041A/8042A/8043A/8044A. Here is the…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to enable snoop mode with HDMI re-driver/re-timer

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Brief Overview of HDMI PHY: The HDMI physical layer is composed of 4 high-speed lanes, one Display Data Channel (DDC) which operates with I2C signaling, Hot Plug Detect (HPD) for device detection, Consumer Electronic Control …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS560DF810: Explanation of Crosspoint and Gearbox Modes

    Lucas Wolter
    Lucas Wolter
    Part Number: DS560DF810 Other Parts Discussed in Thread: DS560DF410 , DS560DF810 and DS560DF410 offer a variety of crosspoint and gearbox modes which can be used for 1:2 fanout, channel crossing, and NRZ/PAM4 modulation conversion. In this thread, I will…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR1601: Receiver Detect Reset for x2 SSD Hot Plug Applications

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR1601 Other Parts Discussed in Thread: DS320PR810 In this E2E FAQ, I am going to provide an overview of RX detect with specific information on the RX detect pulse width and frequency, then, I am going to discuss hot plug functionality…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Linear vs. Limited Mode in Redrivers

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode: In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB216I: How do you create a system with a 10 meter passive cable using a USB2 redriver?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB216I Other Parts Discussed in Thread: TUSB217A , TUSB216-Q1 , , TUSB216 , TUSB211A I want to create a system that can support USB2 while utilizing a 10 meter passive cable. Which redriver(s) should I use, and how should they be configured…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TUSB2046 0 Locked

    3485 views
    9 replies
    Latest over 9 years ago
    by bd5077
  • Not Answered

    ISO 1540 burns out 0 Locked

    1458 views
    1 reply
    Latest over 9 years ago
    by Jonathan Valdez
  • Discussion

    Any recommended layout for ONET8551 for APD application Locked

    753 views
    1 reply
    Latest over 9 years ago
    by Alex Davidson
  • Not Answered

    SN65LVCP114 Power Dissipation RXAUI 0 Locked

    471 views
    2 replies
    Latest over 9 years ago
    by jack dawson
  • Answered

    TL16C554APN - IBIS model 0 Locked

    455 views
    2 replies
    Latest over 9 years ago
    by Hirotaka Matsumoto
  • Answered

    TLK6002: meaning of datasheet annex C 0 Locked

    548 views
    2 replies
    Latest over 9 years ago
    by Pierre Lieutaud
  • Answered

    About power off state of TPS25810 0 Locked

    308 views
    2 replies
    Latest over 9 years ago
    by NickSmith
  • Not Answered

    Problem with my Ti voyage 200 0 Locked

    917 views
    1 reply
    Latest over 9 years ago
    by Blake TI Community
  • Answered

    HDMI switch suggestion request 0 Locked

    373 views
    1 reply
    Latest over 9 years ago
    by Moises Garcia
  • Answered

    DS92LV2412 power-up sequence 0 Locked

    467 views
    1 reply
    Latest over 9 years ago
    by Michael Lu (Santa Clara)
  • Not Answered

    TUSB1210 issue with Zynq-7000 0 Locked

    1571 views
    7 replies
    Latest over 9 years ago
    by Mike Perkins
  • Answered

    POR for PCA9534A 0 Locked

    826 views
    3 replies
    Latest over 9 years ago
    by Jonathan Valdez
  • Not Answered

    RS485 - RS232 in one application - one circuit over two wire Connection - Software configurable 0 Locked

    878 views
    1 reply
    Latest over 9 years ago
    by Ron Michallick
  • Not Answered

    How to Config TLK10022 in four independent low speed channel 0 Locked

    752 views
    2 replies
    Latest over 9 years ago
    by Roger Liao
  • Answered

    DS125BR800A / the CTLE gain table 0 Locked

    696 views
    2 replies
    Latest over 9 years ago
    by Toshiyuki
  • Answered

    TPS65982 as sink for Apple Adapter 0 Locked

    633 views
    2 replies
    Latest over 9 years ago
    by Brian Berner
  • Answered

    Voltage level shift between RS-422 AM26LS32AC and LSF0204 0 Locked

    3840 views
    4 replies
    Latest over 9 years ago
    by Ron Michallick
  • Not Answered

    ESD Protection for CAN Transceiver 0 Locked

    1021 views
    2 replies
    Latest over 9 years ago
    by Jared Becker
  • Answered

    DS90LT012AQ / DS90LV011AQ fail safe biasing 0 Locked

    455 views
    1 reply
    Latest over 9 years ago
    by Lee Sledjeski
  • Not Answered

    Heating Problem on Power Over Coaxial on DS90UB913A 0 Locked

    1008 views
    0 replies
    Started over 9 years ago
    by Kah Joo Lee
<>