Texas Instruments (TI) Isolation support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search isolation IC content or ask technical support questions on everything from digital isolators and isolated transceivers to transformer and isolated drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] Can a digital signal be applied to digital isolator input when its respective VCC is 0V?

    Other Parts Discussed in Thread: ISO6741 Can a digital signal be applied to digital isolator input when its respective VCC is 0V?

  • [FAQ] How can Functional Isolators correct ground shifts and improve noise tolerance on a signal line?

    How can Functional Isolators correct ground shifts and improve noise tolerance on a signal line?

  • [FAQ] What is a functional Isolator?

    What is a functional Isolator?

  • [FAQ] ISO1452: [FAQ] How to configure a RS485 Full-duplex transceiver as Half-duplex?

    Part Number: ISO1452 How do I configure a RS485 Full-duplex transceiver as Half-duplex?

  • [FAQ] What is Distance Through Isolation (DTI)?

    What is Distance Through Isolation (DTI)?

  • [FAQ] What is Comparative Tracking Index (CTI)?

    What is Comparative Tracking Index (CTI)?

  • [FAQ] What is Partial Discharge, Method a, Method b1, and Method b2 tests?

    What is Partial Discharge, Method a, Method b1, and Method b2 tests?

  • [FAQ] My optocoupler has a DTI of 0.4mm. Do you have an opto-emulator that meets this requirement?

    FAQ: Isolation >> Opto-Emulators >> Current FAQ Short Answer This is a common question we receive, as some International Electro-technical Commission (IEC) standards state a minimum Distance Through Insulation (DTI) of 0.4 mm to be used in those applications…

  • [FAQ] What are the different output types of TI Opto-emulators?

    Other Parts Discussed in Thread: ISO8710 FAQ: Isolation >> Opto-Emulators >> Current FAQ What are the different output types of TI Opto-emulators?

  • [FAQ] What is Current Transfer Ratio (CTR)?

    FAQ: Isolation >> Opto-Emulators >> Current FAQ What is Current Transfer Ratio (CTR)?

View FAQ threads