Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask technical support questions on everything from voltage level translation and transceivers to standard logic gates and specialty logic devices. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Other Parts Discussed in Thread: TXH0137D
FAQ: Logic and Voltage Translation > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
Existing level-shifters typically support up to 18 V. For up to 30 V, see the TXH0137D family highlighted below. …
FAQ: Logic and Voltage Translation > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
Consider the worst-case values in the electrical characteristics table; VT+(max) and VT−(min) are what matters for VIH and VIL respectively. See Understanding Schmitt…
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
Choosing a high drive strength device depends on the below:
Static DC drive strength: Drive required for a constant HIGH…
Other Parts Discussed in Thread: TXB0304 , TXB0104
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters >> Current FAQ
The most common reason is due to impedance mismatches.
TXB0304 specifies a stronger output impedance than TXB0104…
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters >> Current FAQ
To mitigate oscillation concerns with devices with edge rate accelerators / one-shots such as TXB / TXS devices, consider below:
Short enough traces for round…
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
When in doubt, use a 0 ohm series resistor on the outputs and adjust accordingly, for your system needs.
This can also be…
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters >> Current FAQ
The devices do not choose the mode. The mode is based on the devices connected to the TXS / LSF devices.
I.e. These are the two devices that are connected to the…
Other Parts Discussed in Thread: TXV0108-Q1 FAQ: Logic and Voltage Translation > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
Data rate depends on the system designers tolerance for various parameters such as VOL / VOH levels, duty cycle distortion…
FAQ: Logic and Voltage Translation > Auto-Bidirectional Level-Shifters > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
Do not use auto-bidirectional level-shifters if the below is applicable. Use fixed or direction control level-shifters instead…
FAQ: Logic and Voltage Translation > Fixed DIR / DIR CNTRL Level-Shifters >> Current FAQ
[FAQ] Should I use Auto-Bidirectional level-shifters for Fixed directional applications?
[FAQ] Can I estimate Data Rate Frequency not given for my voltage level…
