• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 29 subscribers
  • Views 93 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

TMDSRM48HDK: Demo code can't program to Hercules RM48x Development Kit

TMDXRM46HDK: RM46

Paul Hembrook
Prodigy 10 points
Part Number: TMDXRM46HDK
Other Parts Discussed in Thread: UNIFLASH

I have been trying to get my CCS IDE to work with the Hercules Safety MCU Dev Kit RM4 MCU. In the beginning the demo would run, I selected the pre set led. 

I could not compile the code above after I compiled it. It said it failed to verify, much like a previous post. Using CCS 11.1.0

I would like to get Project 0 and CAB Bus bootloader examples to compile and flash onto the board.

Now after trying a few things the board does not run the leds in a pattern when power is applied and the IDE and uniflash utility

I tried no longer sees the xds debug probe on the board. It looks like I may have lost the boot or something on the board or the

code for the debug probe.

What can I do to get the dev board back alive. Then I can address compiling the code.

Paul Hembrook

Presco Inc.

  • 0
    TI__Guru**** 187716 points

    Hi Presco,

    What are your settings for compiling and linking the project?

    If you didn't make any change to the code, the project may not be re-compiled. You can clean first, then built, the project will be re-compiled from the beginning.

    BTW, the HDK has built-in XDS100V2 debugger. Are all the power rails OK (3.3V, 1.2V)? How about LED D12? The D12 should be ON after the board is powered.