TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Arm-based microcontrollers

Arm-based microcontrollers

Arm-based microcontrollers forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
  • Threads 48901 Discussions
Texas Instruments (TI) Microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search for content on other microcontrollers or ask technical support questions on the extensive portfolio of microcontrollers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] TMS570LS1224: After RAM groups self-test is executed using pbistRun() routine generated by HALCOGen, I am not able to access DMA RAM and SRAM. What causes this problem?

    QJ Wang
    QJ Wang
    Part Number: TMS570LS1224 Other Parts Discussed in Thread: HALCOGEN The PBIST DMA RAM test and PBIST SRAM test pass without any issue. The application is not able to access the SRAM or DMA RAM some times.
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
  • [FAQ] TMS570LC4357: Questions regarding FEE (EEPROM) usage on Hercules Microcontrollers

    QJ Wang
    QJ Wang
    Part Number: TMS570LC4357 What are the difference between EEPROM and Flash Emulated EEPROM (FEE)? Is emulated EEPROM protected by ECC, and h ow to enable FEE ECC check? How can I enable the single and double bit Error Corrections? Is Checksum…
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
  • [FAQ] TMS570LS0714: The pin 39 is used for MibSPI1CS[3] and N2HET1[21]. The TRM, datasheet, and HALCOGen don't have PINMUX definition for those two pins. How can I configure pin 39 as N2HET1[21]?

    QJ Wang
    QJ Wang
    Part Number: TMS570LS0714 Other Parts Discussed in Thread: HALCOGEN The TRM, datasheet, and HALCOGen don't have PINMUX definition for those two pins. How can I configure pin 39 as N2HET1[21]?
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
  • [FAQ] MCU-PLUS-SDK-AM243X: Configure Static IP with MCU+ SDK enet_lwip_cpsw or enet_lwip_icssg example

    Prasad Jondhale
    Prasad Jondhale
    Part Number: MCU-PLUS-SDK-AM243X Other Parts Discussed in Thread: DP83869 Hi, Can you please share steps to configure Static IP with MCU+ SDK enet_lwip_cpsw or enet_lwip_icssg example? Regards, Prasad
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
  • [FAQ] TMS570LC4357: Why should the nTRST signal on Hercules devices (TMS570LC43x, TMS570LSx, RM4x and RM57) be pulled LOW?

    QJ Wang
    QJ Wang
    Part Number: TMS570LC4357 Should the nTRST JTAG signal of Hercules devices be pulled low on PCB board?
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
  • [FAQ] TMS570LC4357: Questions regarding F021 Flash erase and program on Hercules devices (TMS570LCx, TMS570LSx, RM4x, and RM57Lx)

    QJ Wang
    QJ Wang
    Part Number: TMS570LC4357 Can F021 Flash APIs run in user mode? How does RWAIT work? Can we change the device system clock before erasing or programming the flash? How to calculate and program ECC to ECC space when programming the…
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
  • [FAQ] MCU-PLUS-SDK-AM243X: Use SBL's memory from application

    Prasad Jondhale
    Prasad Jondhale
    Part Number: MCU-PLUS-SDK-AM243X How can I use SBL's memory from application once it is done executing as it will be wasted otherwise?
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
  • [FAQ] TMS570LC4357: How to get source code of F021 flash APIs

    QJ Wang
    QJ Wang
    Part Number: TMS570LC4357 How to get the source files for F021 flash APIs
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
  • [FAQ] TMS570LC4357: TI ARM compiler is not qualified to any safety standards. How to use CQKIT to perform coverage check of TI ARM compiler for functional safety application?

    QJ Wang
    QJ Wang
    Part Number: TMS570LC4357 The Safety Compiler Qualification Kit (CQKIT): supports compiler coverage analysis
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
  • [FAQ] MCU-PLUS-SDK-AM243X: How to debug sbl_qspi (for am263 and am273) or sbl_ospi (for am243) or an application which is booted via OSPI/QSPI boot ?

    Aakash Kedia
    Aakash Kedia
    Part Number: MCU-PLUS-SDK-AM243X Other Parts Discussed in Thread: UNIFLASH What is the correct way to debug sbl_qspi/sbl_ospi examples provided in sdk or another example booted via QSPI/OSPI ? Most of the users are familiar with CCS load method and…
    • Answered
    • over 3 years ago
    • Arm-based microcontrollers
    • Arm-based microcontrollers forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    TMS570LS3137: EEPROM Wear Leveling 0 Locked

    540 views
    1 reply
    Latest over 8 years ago
    by Vishwanath Reddy
  • Answered

    CCS/EK-TM4C1294XL: EK-TM4c1294xl: SPI Rx FIFO 0 Locked

    1124 views
    7 replies
    Latest over 8 years ago
    by Charles Tsai
  • Answered

    using SSI on Hercules 0 Locked

    2454 views
    24 replies
    Latest over 8 years ago
    by Miguel Amezcua Peregrina
  • Not Answered

    N2HET example using multiple IO pins 0 Locked

    641 views
    3 replies
    Latest over 8 years ago
    by jimj2713
  • Answered

    LAUNCHXL2-RM57L: Resetting an Interrupt 0 Locked

    415 views
    3 replies
    Latest over 8 years ago
    by Max Hansen
  • Not Answered

    DK-TM4C129X: Retrieve IPs using UpdateBOOTP 0 Locked

    1608 views
    9 replies
    Latest over 8 years ago
    by Sai Reddy
  • Answered

    EK-TM4C123GXL: Modifying Tivaware I2C code to fit with my Controller 0 Locked

    1897 views
    11 replies
    Latest over 8 years ago
    by Charles Tsai
  • Not Answered

    Starterware/TM4C1230H6PM: Uart Tx buffer change value 0 Locked

    442 views
    3 replies
    Latest over 8 years ago
    by Amit Ashara
  • Suggested Answer

    How to setup an ARM assembly language only project in CCS using MCU TM4C129X 0 Locked

    2944 views
    14 replies
    Latest over 8 years ago
    by cb1_mobile
  • Answered

    TM4C123GH6PM: PWM jitter by using the PIOSC 0 Locked

    1181 views
    5 replies
    Latest over 8 years ago
    by cb1_mobile
  • Not Answered

    TMS570LS3137: die size? 0 Locked

    389 views
    1 reply
    Latest over 8 years ago
    by Chuck Davenport
  • Not Answered

    RM57L843: issue with circular buffer using DMA and dummy channel 0 Locked

    807 views
    2 replies
    Latest over 8 years ago
    by Trevor Walker
  • Suggested Answer

    Using the TM4C129 TIVA device as an embedded web server 0 Locked

    2355 views
    4 replies
    Latest over 8 years ago
    by Mohammed Fawzy
  • Not Answered

    TMS570LC4357: Boot Sequence. 0 Locked

    731 views
    2 replies
    Latest over 8 years ago
    by Sharif Shaik
  • Not Answered

    RTOS/TM4C1294NCPDT: TCP ECHO program is not working with RJ45(in-built transformer). 0 Locked

    821 views
    7 replies
    Latest over 8 years ago
    by Shaheen Shamshad
  • Answered

    CCS/EK-TM4C1294XL: Hibernate RTC not interrupting in the right way 0 Locked

    594 views
    2 replies
    Latest over 8 years ago
    by Helder Sales
  • Not Answered

    UDP Using Static IP not working,in TM4C1294NCPDT 0 Locked

    2043 views
    11 replies
    Latest over 8 years ago
    by Krishnan G Nair
  • Answered

    TM4C1290NCPDT: Hibernation Module Initialization 0 Locked

    735 views
    4 replies
    Latest over 8 years ago
    by Andrew Chavarria
  • Not Answered

    multiple serial communication in TM4C1294. 0 Locked

    2397 views
    13 replies
    Latest over 8 years ago
    by Amit Ashara
  • Not Answered

    EK-TM4C1294XL: FPU activation on launchpad's TM4C1294NCPDT 0 Locked

    436 views
    2 replies
    Latest over 8 years ago
    by John Piliounis
<>