Texas Instruments (TI) C2000™ microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search C2000™ microcontroller content or ask technical support questions on our families of real-time control MCUs. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] C2000WARE: How to configure CMPSS and EPWM for EDGE trigger instead of LEVEL trigger

    Part Number: C2000WARE Tool/software: Situation example: The CMPSS's compared voltage is set as 1.5V from internal DAC / external signal, once the sensed voltage on positive pin is higher than negative pin 1.5V, then trigger ONCE interrupt. Then…

  • [FAQ] C2000-SAFETI-DIAGNOSTICS-LIB: F2837x/F2807x Software Diagnostic Library in EABI

    Part Number: C2000-SAFETI-DIAGNOSTICS-LIB Other Parts Discussed in Thread: C2000WARE Tool/software: How can I use the C2000-SAFETI-DIAGNOSTICS-LIB in an EABI project when existing .lib files are COFF ABI?

  • [FAQ] Where can I find C2000 end-equipment resources and reference designs?

    Where can I find existing C2000 resources for specific end-equipments as well as reference designs featuring C2000 devices ?

  • [FAQ] Where can I find C2000 device migration resources?

    What resources are there for migrating from one C2000 device to another?

  • [FAQ] Where can I find IP/peripheral collateral and FAQs for C2000 devices?

    Other Parts Discussed in Thread: TINA-TI , ADS8364 , TMS320F2812 , PSPICE-FOR-TI , TMS320F2811 , TMS320F2810 , TIDM-02006 , ADS8361 Where can I find IP/peripheral collateral and FAQs for C2000 devices?

  • [FAQ] C2000WARE: When we try to build the same C2000 project on a different computer we get the build errors. How can we resolve these errors?

    Part Number: C2000WARE Tool/software: When sharing, exporting, or migrating CCS projects there may be issues with building the same project due to paths being incorrect. The error below is an example or the following gmake: Target 'all' not…

  • [FAQ] C2000WARE: How do I reset JTAG logic with software in a noisy environment?

    Part Number: C2000WARE Tool/software: In some systems, noise on the JTAG pins/traces will result in the debug architecture of the MCU issuing commands that stop the operation of the MCU. In the following devices, this problem can sometimes be mitigated…

  • [FAQ] TMS320F28P559SJ-Q1: The procedure to recover from CAN Bus-Off

    Part Number: TMS320F28P559SJ-Q1 Tool/software: The procedure to recover from CAN Bus-Off

  • [FAQ] Where do I find frequently asked questions about the C2000 GPIO?

    Where do I find frequently asked questions about the C2000 GPIO?

  • [FAQ] Where do I find frequently asked questions about the C2000 SDFM?

    Where do I find frequently asked questions about the C2000 SDFM?

View FAQ threads