Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] RE: TPS65381-Q1: Debug Mode

    Other Parts Discussed in Thread: TPS65381-Q1 , TPS65381A-Q1 Kindly reply to my TPS65381-Q1: Debug Mode question And I have another query. ERROR_PIN_FAIL is always set even though ERROR/WDI pin is always high (MCU ESM Module detects no failure) and I am…

  • [FAQ] TPS61220: what happen if VIN is higher than VOUT

    Part Number: TPS61220 Other Parts Discussed in Thread: TPS61291 , TLV61220 What is the behavior of the TPS61220 when the VIN is near or higher than VOUT

  • [FAQ] TPS43340-Q1: TPS43340-Q1 EN pin logic threshold.

    Part Number: TPS43340-Q1 I’m evaluating TPS43340-Q1 on headunit project and found that the device is disabled when EN pin is ~1.0V. Is this expected behavior of the device’s EN pin logic threshold?

  • [FAQ] TPS65218D0: What difference between this new version and the old version?

    Part Number: TPS65218D0 Other Parts Discussed in Thread: TPS65218 Hi, I noted TPS65218 has been NRNDed. The new version is TPS65218D0. I am wondered what is the difference of this new version? Is the technical issue (DCDC4 cannot start up) with the…

  • [FAQ] TPS65311-Q1: VREG FET operation

    Part Number: TPS65311-Q1 Hi, When 5V is supplied to EXTSUP pin, how the VREG FET does operate(as regulator or Power SW)? I would like to know if "VREGDROP(=200mV[max])" is I*R drop. Best Regards, Kuramochi

  • [FAQ] Multiphase FAQ & Answers - TPS53647, TPS53667, TPS53681

    Other Parts Discussed in Thread: TPS53647 , TPS53667 , TPS53681 , TPS53622 , TPS53659 , TPS53679 Q1: How to properly turn off phases if you don’t need the max phase number? Pull the appropriate CSP line up to the controller supply voltage V3R3 to select…

  • [FAQ] TPS51200: Frequently Asked Questions and Answers

    Part Number: TPS51200 General Questions: Q: What types of DDR does TPS51200 support? A: TPS51200 supports DDR, DDR2, DDR3, DDR3L, LP DDR3 (Low power DDR3) and DDR4. Q: How to calculate the power dissipation on TPS51200. A: TPS51200 is a linear…

  • [FAQ] TPS51206: Frequently Asked Questions and Answers

    Part Number: TPS51206 General Questions: Q: What types of DDR does TPS51206 support? A: TPS51206 supports DDR2, DDR3, DDR3L, LP DDR3 (Low power DDR3) and DDR4. Q: How to calculate the power dissipation on TPS51206. A: TPS51206 is a linear…

  • [FAQ] LM388X Frequently Asked Questions and Answers

    This document addresses most frequently asked questions fro the LM388X analog sequencer. Pleae read thist first to ensure that you questions are covered before posting. 5164.LM388X Frequently Asked Questions and Answers.pdf Thanks

  • [FAQ] TPS65072EVM-430: TPS65072 EVM

    Part Number: TPS65072EVM-430 I would like to purchase TPS65072EVM to get exposure on PMIC .When i am trying to get the user manual of TPS6507X EVM software i could not able to get.And i would like to know what kind of tests i can perform on this EVM…

View FAQ threads