TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] TPS43330-Q1: Differences between TPS43330-Q1 & TPS43330A-Q1

    Phil Yi
    Phil Yi
    Part Number: TPS43330-Q1 This thread applies to TPS43330-Q1. In device TPS43330 (non-A version): When device in LPM and waking up EXTSUP gets shorted to VREG and that may cause a restart of the device (including running buck regulators): High-IQ in…
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS65320-Q1: What's the difference between different version: TPS65320-Q1 and TPS65320A/B/C/D-Q1?

    Phil Yi
    Phil Yi
    Part Number: TPS65320-Q1 This thread applies to TPS65320-Q1. TPS65320x-Q1 Revision History.pdf
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS65910: TPS65910A3A1RSLR Replacement

    Phil Yi
    Phil Yi
    Part Number: TPS65910 This thread applies to TPS65910x. All variants based on the device are OTP programmed for specified processor; there is no any drop-in replacement for any specified variant; including the TPS65910A3A1RSLR.
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS65320-Q1: The debounce time of the UVLO protection.

    Phil Yi
    Phil Yi
    Part Number: TPS65320-Q1 This thread applies to TPS65320-Q1. There is no debounce time on the UV/OV for this device; it's just a Schmitt trigger after a UV/OV comparator.
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] What is the difference between filtered and unfiltered gauging parameters?

    Wyatt Keller
    Wyatt Keller
    For most Impedance Track TI battery gauges, a smoothing engine is used to help minimize jumps in the State of Charge (SoC) reported by the gauge. During normal operation of the gauge Full Charge Capacity (FCC) and Remining Capacity (RC) are calculated…
    • Answered
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] What information does TI need to help with learning/accuracy/operation related questions?

    Wyatt Keller
    Wyatt Keller
    Other Parts Discussed in Thread: GPCCHEM , BQSTUDIO To most efficiently help debug State of Charge accuracy issues, problems encountered during the learning cycle process, or any other function related to the gauge like protection, there is some information…
    • Answered
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] What considerations are needed to de-rate the battery charge voltage?

    Wyatt Keller
    Wyatt Keller
    Other Parts Discussed in Thread: GPCCHEM Some applications require a reduction in the charging voltage, one reason can be to increase the cycle life of the battery. Reducing the charging voltage will often cause some discrepancies with the State of…
    • Answered
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] How do I Find a Chemistry ID for my Battery?

    Wyatt Keller
    Wyatt Keller
    Other Parts Discussed in Thread: EV2400 When looking for the correct chemistry ID for Impedance Track gauges, the GPCCHEM tool should be used. This tool helps find the best matching chemistry ID for the battery. The chemistry ID contains the baseline…
    • Answered
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] How to Calculate State of Charge (SoC) Accuracy

    Wyatt Keller
    Wyatt Keller
    It is common to verify the accuracy of the gauge SoC after learning cycles or battery characterization by doing some math on the discharge logs for capacity and comparing it with the gauge’s predictions. The voltage range used to define 100% and 0%…
    • Answered
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] Impedance Track FAQs

    Wyatt Keller
    Wyatt Keller
    Impedance Track FAQ Home Page This is the home page for common Impedance Track (IT) questions. Please note that not all FAQs will be applicable for the specific gauge being used, as functions have been added over time. FAQs What information does…
    • Answered
    • over 3 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    BQ4050: To Enable PROCHOT Assertion 0 Locked

    673 views
    14 replies
    Latest over 1 year ago
    by Tiger Zhou
  • Suggested Answer

    TPS92643-Q1: questions 0 Locked

    252 views
    1 reply
    Latest over 1 year ago
    by Jaron Wilson
  • Not Answered

    BQ40Z50:BQ 40Z50 进入睡眠模式和shutdown 模式 0 Locked

    1091 views
    1 reply
    Latest over 1 year ago
    by Anthony
  • Not Answered

    BQ40Z50-R2: BQ40Z50-R2 0 Locked

    190 views
    1 reply
    Latest over 1 year ago
    by Anthony
  • Not Answered

    BQ40Z50-R2: FCC update is low 0 Locked

    1254 views
    38 replies
    Latest over 1 year ago
    by Anthony
  • Not Answered

    BQ40Z50-R1: Calibration Load Current Inquiry 0 Locked

    270 views
    3 replies
    Latest over 1 year ago
    by Anthony
  • Answered

    UCC27288: a HB gate drive can support external boot diode and has interlock function 0 Locked

    349 views
    3 replies
    Latest over 1 year ago
    by Richard Herring
  • Answered

    Need LOAD SWITCH with Low Temperature & Rise Time Requirements 0 Locked

    599 views
    6 replies
    Latest over 1 year ago
    by Monty Offutt
  • Suggested Answer

    UCC28070-Q1: Three-Phase Semi-Bridgeless PFC Topology 0 Locked

    1851 views
    6 replies
    Latest over 1 year ago
    by Ulrich Goerke
  • Suggested Answer

    LM5148: How to design circuit 0 Locked

    220 views
    1 reply
    Latest over 1 year ago
    by EricLee
  • Suggested Answer

    EV2400: DQ Supported Development Kit 0 Locked

    267 views
    3 replies
    Latest over 1 year ago
    by Jonny
  • Suggested Answer

    BQ35100: bq35100 parameters 0 Locked

    384 views
    1 reply
    Latest over 1 year ago
    by Diego
  • Suggested Answer

    BQ35100EVM-795: Accuracy of bq35100 voltage reading? 0 Locked

    278 views
    1 reply
    Latest over 1 year ago
    by Diego
  • Not Answered

    BQ34Z100-R2: Automated Calibration of BQ76942 and BQ34Z100-R2 Without BQStudio 0 Locked

    774 views
    6 replies
    Latest over 1 year ago
    by Diego
  • Not Answered

    BQ76942: BQ76942 arduino interface 0 Locked

    460 views
    3 replies
    Latest over 1 year ago
    by Thomas Rainey
  • Suggested Answer

    LM431: regulated voltage 0 Locked

    203 views
    1 reply
    Latest over 1 year ago
    by Walter Zollinger
  • Not Answered

    BQ79616: Not communicating and LDO PIN voltage is 4.9 volts 0 Locked

    329 views
    3 replies
    Latest over 1 year ago
    by David Ray
  • Answered

    BQ25622: BQ25622 linux driver 0 Locked

    324 views
    3 replies
    Latest over 1 year ago
    by Ning T
  • Suggested Answer

    TUSB546EVM: TUSB546EVM -> TUSB564RNQEVM USB connection 0 Locked

    339 views
    3 replies
    Latest over 1 year ago
    by David (ASIC) Liu
  • Not Answered

    BQ24610: Audible noise and excessive heat 0 Locked

    336 views
    3 replies
    Latest over 1 year ago
    by Christian Moyer
<>