TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] BQ24610, BQ24616, BQ24617, BQ24618, & BQ24630: Layout guidelines and example

    Michael Emanuel35
    Michael Emanuel35
    Part Number: BQ24610 Other Parts Discussed in Thread: BQ24617 , BQ24616 , , BQ24618 , BQ24630 Please see the below document for the layout guidelines and example for the BQ24610, BQ24616, BQ24617, BQ24618, and BQ24630. Layout Guidelines and Example…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS3840: PFET based disconnect on overvoltage

    Ajay Padgaonkar
    Ajay Padgaonkar
    Part Number: TPS3840 In case of an overvoltage situation, how can the downstream power tree be disconnected to protect it from such overvoltage? Can reset ICs not only sense the overvoltage but also drive a PFET switch to turn it off?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62903: Reasons for Vout variations away from the expected value?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62903 Other Parts Discussed in Thread: TPS62901 , TPS629210-Q1 What are some of the causes of output voltage variations in the TPS62901/2/3 buck converters?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62130A: How to use the Power Good (PG) pin?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62130A Other Parts Discussed in Thread: TPS62130 , What is the PG pin used for and what are the differences between the TPS62130 and TPS62130A?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25171-Q1: Configuration Pins and Design Questions

    Bill Johns
    Bill Johns
    Part Number: BQ25171-Q1 The device can be configured to charge Li-Ion, NiMH and LiFePO using external pins. Can the configuration be changed during operation? Any other things I should note?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why does ICHG reduce when reaching the maximum duty cycle for the BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ24190, BQ24192, BQ24195, BQ24195L, BQ24196, BQ24295, BQ24296, BQ24296M, BQ24259?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25890 The charger is basically a step-down DC-DC (buck) converter. It requires the input voltage to be higher than the output voltage with some headroom for normal operations. The maximum duty cycle specification is one of the factors…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why does ICHG reduce during input voltage DPM (Dynamic Power Management) or the input current DPM for the chargers BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ24190, BQ24192, BQ24195, BQ24195L, BQ24196,...

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25890 When the input source is over-loaded, it is either from the current exceeding the IINDPM (Input Current Limit) or from the voltage dropping below VINDPM (Input Voltage Limit). For the current to cause the input source to be…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25618: [FAQ] Why does ICHG reduce when reaching the maximum duty cycle for the BQ25618, BQ25618E, BQ25619, BQ25611D, BQ25616, BQ25600, BQ25600D, BQ25601, BQ25601D, BQ25606?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25618 The charger is basically a step-down DC-DC (buck) converter. It requires the input voltage to be higher than the output voltage with some headroom for normal operations. The maximum duty cycle specification is one of the factors…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25618: Why does ICHG reduce during the input current DPM (Dynamic Power Management) or the input voltage DPM for the chargers BQ25618, BQ25618E, BQ25619, BQ25611D, BQ25616, BQ25600, BQ25600D, BQ25601, BQ25601D, BQ25606?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25618 When the input source is over-loaded, it is either from the current reaching the IINDPM (Input Current Limit) or from the voltage dropping to the VINDPM (Input Voltage Limit). For the current to cause the input source to be…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS53353: [FAQ] VFB at Light Load Current vs Heavier Load Current

    Alec Biesterfeld
    Alec Biesterfeld
    Part Number: TPS53353 If using skip mode, a higher VOUT is expected at a light load when compared to a heavier load when the device is operating in CCM. This is not an artifact of the reference voltage (or feedback voltage) changing as a function of load…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    LMR34215-Q1: JASO D1, D2 0 Locked

    398 views
    5 replies
    Latest over 4 years ago
    by Daniel Li14
  • Suggested Answer

    UCC28180: Schematic review 0 Locked

    550 views
    1 reply
    Latest over 4 years ago
    by David Huang33
  • Suggested Answer

    BQ27421-G1: bq27421-G1 Gauging Parameter Calculator 0 Locked

    944 views
    9 replies
    Latest over 4 years ago
    by Mikhail Rovdo
  • Answered

    TPS55332-Q1: thermal shutdown 0 Locked

    310 views
    4 replies
    Latest over 4 years ago
    by cpt_mac
  • Answered

    TPS63010: Is there a maximum recommended capacitance for the Vina bypass cap on pin B3 0 Locked

    308 views
    2 replies
    Latest over 4 years ago
    by Bob Kruse
  • Not Answered

    TPS2546-Q1: current is lower than setting 0 Locked

    199 views
    2 replies
    Latest over 4 years ago
    by Ansel Song
  • Suggested Answer

    TPS51116: Loop simulation 0 Locked

    260 views
    1 reply
    Latest over 4 years ago
    by Weidong Zhu
  • Answered

    LP2985-N:difference between LP2985AIM5-3.3 and LP2985AIM5-3.3/NOPB 0 Locked

    511 views
    1 reply
    Latest over 4 years ago
    by kai klaas69
  • Answered

    LM5164-Q1: Switching Frequency 0 Locked

    494 views
    4 replies
    Latest over 4 years ago
    by Rohan Patwardhan1
  • Answered

    BQ24297: USB communication 0 Locked

    437 views
    5 replies
    Latest over 4 years ago
    by Ning T
  • Answered

    BQ25606: Output Inductance Value for SYS output 0 Locked

    174 views
    1 reply
    Latest over 4 years ago
    by Ning T
  • Answered

    BQ25792: Ship FET is not properly working from VBAT only 0 Locked

    588 views
    2 replies
    Latest over 4 years ago
    by George Deborin
  • Suggested Answer

    LED Dimming solution to replace the IC of MPS. 0 Locked

    197 views
    1 reply
    Latest over 4 years ago
    by Sean Zhou
  • Answered

    voltage to current source to drive a laser diode 0 Locked

    993 views
    1 reply
    Latest over 4 years ago
    by Sean Zhou
  • Not Answered

    Search LED Dimming solution to replace the IC of MPS. 0 Locked

    172 views
    1 reply
    Latest over 4 years ago
    by Sean Zhou
  • Answered

    TLV61046A: Boost converter to power a solenoid 0 Locked

    610 views
    6 replies
    Latest over 4 years ago
    by Yichen Xu
  • Answered

    UCC28782EVM-030: UCC28782-030 SR REGULATOR 0 Locked

    548 views
    5 replies
    Latest over 4 years ago
    by Jaden Ning
  • Answered

    UCC27211A: UCC27211 Bootcap value 0 Locked

    1265 views
    2 replies
    Latest over 4 years ago
    by Richard Herring
  • Suggested Answer

    UCC5350: AC Specs on Capacitive Isolators 0 Locked

    290 views
    4 replies
    Latest over 4 years ago
    by Art Mecina
  • Not Answered

    BQ27742-G1: Remaining uncompensated battery capacity and SoC decreases rapidly after a few cycles 0 Locked

    386 views
    10 replies
    Latest over 4 years ago
    by Nick Brylski
<>