Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
I’m working on customer board porting, and want to know how to modify QSPI/OSPI flash layout for SPL/u-boot booting from QSPI/OSPI with TI AM64x Linux SDK.
eMMC flash and boot work as expected on AM62x-SK E2 board from Power-On-Reset (POR), but an issue as listed below is observed on AM62x-SK E2. The Issue observed After successful eMMC boot from cold POR, WARM RESET options as listed below doesn’t re-boot…
Part Number: AM625
Hi, my customer has a question about using an output from the TPS6593 PMIC + a FET to control ON/OFF for 1.8V VPP on the processor? They are trying to see if they can get by without using a dedicated LDO for 1.8V VPP.
Part Number: TDA4VM Other Parts Discussed in Thread: DRA829 , , DRA821 , TDA4VH
Hi
I want to use the new Native Linux Driver introduces in PSDK Linux 8.4. How do I start?
Part Number: AM625
Hello,
I am using the AM62 SK eva kit with PROCESSOR-SDK-LINUX-AM62 08.04.01.03
As I understand MAIN_UART1 and WKUP_UART0 is used by the DM and TIFS firmware.
This is the configuration
MAIN_UART0: Used for Linux and U-Boot…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62
Hi everybody ,
customer would like to have Jtag connections/capabilities on their production board .
I suggested to copy SK-AM62 but here are questions :
- do you need to implement…
Part Number: AM625
We are facing problem when connecting a SPI Nor (W25Q128VEIQ) to OSPI CS0.
Basically it is working but from time to time it comes to errors during SF PROBE command in u.boot.
Please find attached the CLK Signal measured during…
