TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198362 Discussions
  • Not Answered

    DSP MMU Error Fault! 0 Locked

    209 views
    1 reply
    Latest over 12 years ago
    by Cvetolin Shulev-XID
  • Suggested Answer

    TImer in Sys/bios 0 Locked

    1360 views
    7 replies
    Latest over 12 years ago
    by Yokoyama, Atsushi
  • Not Answered

    How to use uart in dm6446 processor ? 0 Locked

    182 views
    0 replies
    Started over 12 years ago
    by Anand Vibhu
  • Answered

    AM335x Matrix Keypad interface 0 Locked

    1261 views
    3 replies
    Latest over 12 years ago
    by Gururaja Hebbar
  • Not Answered

    omap3 linux etb analysis 0 Locked

    311 views
    2 replies
    Latest over 12 years ago
    by wending weng1
  • Not Answered

    DM36x USB host: how to test the eye diagram 0 Locked

    2535 views
    2 replies
    Latest over 12 years ago
    by voice shen
  • Not Answered

    PRU Execution timing regarding R31 reads 0 Locked

    693 views
    3 replies
    Latest over 12 years ago
    by PratheeshGangadhar
  • Answered

    How to use make menuconfig in kernel directory 0 Locked

    3749 views
    3 replies
    Latest over 12 years ago
    by enson Steven
  • Not Answered

    Can we combine xloader/uboot as single bootloader 0 Locked

    617 views
    3 replies
    Latest over 12 years ago
    by Former Member
  • Not Answered

    Hyperlink protocal question 0 Locked

    144 views
    1 reply
    Latest over 12 years ago
    by Steven Ji
  • Not Answered

    High level archtecture of porting customer board to AM335x 0 Locked

    165 views
    0 replies
    Started over 12 years ago
    by wayne zhou
  • Not Answered

    How to use usb_dev_serial.inf in Starterware? 0 Locked

    417 views
    2 replies
    Latest over 12 years ago
    by Oplk.Ray
  • Not Answered

    Connect EVM6678 to FPGA through PCI-E 0 Locked

    2943 views
    13 replies
    Latest over 12 years ago
    by pascal alvin
  • Not Answered

    DDR Memory Self Refresh and Controller Power Down 0 Locked

    2835 views
    1 reply
    Latest over 12 years ago
    by Mukul Bhatnagar
  • Not Answered

    OMX vlpb capture_encode 0 Locked

    497 views
    8 replies
    Latest over 12 years ago
    by Roberto Borja
  • Discussion

    Sysbios locks for about 2 seconds after using gateAll functions Locked

    397 views
    5 replies
    Latest over 12 years ago
    by ScottG
  • Answered

    AM335X SERIAL FLASHER TOOL 0 Locked

    293 views
    3 replies
    Latest over 12 years ago
    by BrandonAzbell
  • Discussion

    FAXLIB, FM module's API run off the rails Locked

    451 views
    6 replies
    Latest over 12 years ago
    by buga tti
  • Suggested Answer

    OMAP L138 ARM memory setting problem 0 Locked

    362 views
    2 replies
    Latest over 12 years ago
    by BrandonAzbell
  • Answered

    CSI Sensor integration in OMAP4460: Not getting interrupts for line start/frame start 0 Locked

    515 views
    3 replies
    Latest over 12 years ago
    by Mayank Mangla
<>