TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198291 Discussions
  • Answered

    Error in Compilation DSPlink 0 Locked

    133 views
    1 reply
    Latest over 13 years ago
    by GAnthony
  • Suggested Answer

    VID/PID 0 Locked

    710 views
    9 replies
    Latest over 13 years ago
    by Steve Tsang
  • Not Answered

    Request syslink FrameQ sample 0 Locked

    306 views
    3 replies
    Latest over 13 years ago
    by GAnthony
  • Answered

    Support for AET and EXC modules in SYS/BIOS 6 0 Locked

    756 views
    9 replies
    Latest over 13 years ago
    by Jonathan White
  • Answered

    Boot settings for PLL 0 Locked

    192 views
    1 reply
    Latest over 13 years ago
    by Chad Courtney
  • Answered

    TMS320C6455 EOL 0 Locked

    261 views
    1 reply
    Latest over 13 years ago
    by Chad Courtney
  • Not Answered

    Looking For "gst-prebuilt-v4l2-0.10.28.tar.gz" 0 Locked

    172 views
    1 reply
    Latest over 13 years ago
    by Amit Prasad1
  • Not Answered

    OMAP-L138 Secure Boot - Silicon Rev 0 Locked

    311 views
    1 reply
    Latest over 13 years ago
    by Mukul Bhatnagar
  • Not Answered

    I2C module access in OMAP L138 0 Locked

    280 views
    1 reply
    Latest over 13 years ago
    by Stefan Gehrig
  • Answered

    CCSv5 - Created clock in RTSC editor but does not run 0 Locked

    618 views
    3 replies
    Latest over 13 years ago
    by Ashish Kapania
  • Not Answered

    OMAP-L138 I2C controller problem ?? 0 Locked

    538 views
    0 replies
    Started over 13 years ago
    by Stefan Gehrig
  • Answered

    SYS/BIOS zero latency interrupts IER lockup 28069 0 Locked

    1063 views
    5 replies
    Latest over 13 years ago
    by Mike Volzer
  • Answered

    SYS/BIOS issue on tms320dm8168 0 Locked

    471 views
    6 replies
    Latest over 13 years ago
    by studinstru sggs
  • Answered

    How to reduce bios6 build time in IPNC GA3.0 ? 0 Locked

    285 views
    2 replies
    Latest over 13 years ago
    by kiwook yoon
  • Not Answered

    USB OTG support on L138 linux 0 Locked

    977 views
    7 replies
    Latest over 13 years ago
    by Francis Kumar
  • Not Answered

    Interfacing a parallel command / data LCD With AM3517 0 Locked

    234 views
    1 reply
    Latest over 13 years ago
    by Renjith Thomas
  • Not Answered

    DM6437's DDR2 Controller Can NOT driver the data bus 0 Locked

    390 views
    7 replies
    Latest over 13 years ago
    by caroid texan
  • Not Answered

    Audio in uboot 0 Locked

    238 views
    0 replies
    Started over 13 years ago
    by santosh vastrad
  • Not Answered

    Not bale to capture Raw data!! 0 Locked

    275 views
    0 replies
    Started over 13 years ago
    by Ravikiran HV
  • Answered

    Clock Generation of 12MHz to feed to the TLV320AIC3104 codec 0 Locked

    294 views
    2 replies
    Latest over 13 years ago
    by Israel Cepeda
<>