TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] 66AK2H14: I2C Boot Parameter Table correction in datasheet, SPRS866G

    Shankari G
    Shankari G
    Part Number: 66AK2H14 Hi, Please provide the correction in the " I2C Boot Parameter Table in datasheet, SPRS866G" for 66AK2Hxx devices.
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: Does SDK8.5 MCAL CDDIPC supports communication with A72 running Linux

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM If not, Is there a patch to support communication with A72 running Linux ?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62P / AM62P-Q1 Custom board hardware design – OLDI (Open LVDS Display Interface) capabilities

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Other Parts Discussed in Thread: AM620-Q1 , AM62P , AM625 , SK-AM62P-LP Hi TI Experts, I have the below queries regarding the OLDI interface Supported display configurations. Query regarding 8-lane, 4-lane and electrical compatibility. Is there…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: Ability to change boot mode in SW

    Karan Saxena
    Karan Saxena
    Part Number: TDA4VM I do not have UART boot mode on my custom board due to lack of switch / pins which can configure the boot mode. Is there a way by which I can change the boot mode in software using gel scripts?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J721E: How to enable trace/assert in VHWA drivers?

    Brijesh Jadav
    Brijesh Jadav
    Part Number: PROCESSOR-SDK-J721E By default trace and assert functionalities are disabled in the VHWA PDK driver. This article explains how to enable it in the VHWA drivers.
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: TDA4 Drive Strength Controls

    B.C.
    B.C.
    Part Number: TDA4VM-Q1 What are the drive strength controls for TDA4?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] How to run OTP Keywriter on SK-AM64B

    Lalie Arnoud
    Lalie Arnoud
    Part Number: SK-AM64B Other Parts Discussed in Thread: TCA9538 Hello TI, I’m currently working on TI’s SK-AM64B boards, trying to move them from HS-FS to HS-SE mode. To do so, I’m using the OTP Keywriter tool with MCU+ SDK for AM64x in its latest…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] AM62X-PET-CALC: AM62x Sysconfig power confict warning

    Jingcheng ye
    Jingcheng ye
    Part Number: AM62X-PET-CALC Hi TI When i finish the PINMUX config and power domain config, there is confict message show as below,Can i suppress these two warning ? As the MCU GPIO is 3v3 level ,so i connect the VDDSHV_MCU to 3v3 domain. BR…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] AM64X: How to Run MCU+ SDK GPIO_INPUT_INTERRUPT example for R5FSS0-0 with Linux running on A53

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Problem Description The MCU+ SDK comes with a GPIO_INPUT_INTERRUPT example for R5FSS0-0. This example configures a GPIO pin to generate an interrupt and then registers an interrupt handler to service the GPIO interrupt. This example…
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM62 : How to configure the GPIO interrupt on AM62X in MCU+SDK.

    Swargam Anil
    Swargam Anil
    Part Number: SK-AM62 What is GPIO? The General-Purpose Input/output (GPIO) peripheral provides dedicated general-purpose pins that can be configured as either inputs or outputs. GPIO can be used in three modes: *Input *Output *Interrupt …
    • over 2 years ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198386 Discussions
  • Not Answered

    Problem with core local reset... 0 Locked

    205 views
    1 reply
    Latest over 13 years ago
    by ArunMani
  • Discussion

    How long shall we wait for the abandon of the export control for Beagle board? Locked

    394 views
    10 replies
    Latest over 13 years ago
    by Emily Wollin
  • Not Answered

    Current spike when resetting. 0 Locked

    154 views
    0 replies
    Started over 13 years ago
    by John Fielden
  • Answered

    NANDInfoInit 0 Locked

    393 views
    5 replies
    Latest over 13 years ago
    by Vishwanath Kamalapur
  • Not Answered

    about fiq interrupt in TI8148 0 Locked

    157 views
    0 replies
    Started over 13 years ago
    by Max Cheng
  • Answered

    SYS/BIOS, TMS320C28346, CCS task sample code 0 Locked

    316 views
    1 reply
    Latest over 13 years ago
    by Sasha Slijepcevic
  • Not Answered

    Problem with switch test for eZDSP5535 0 Locked

    231 views
    0 replies
    Started over 13 years ago
    by David Steele
  • Not Answered

    DM368IPNC memory leak 0 Locked

    966 views
    3 replies
    Latest over 13 years ago
    by Raghu Kudva
  • Not Answered

    DM36x H.264 encoder LBRmaxpicsize 0 Locked

    760 views
    3 replies
    Latest over 13 years ago
    by Veeranna Hanchinal
  • Not Answered

    questions in LIDD user guide : anybody could confirm the LIDD mode supports DMA or not 0 Locked

    542 views
    3 replies
    Latest over 13 years ago
    by RY9983
  • Answered

    DSPLIB DSP_fft32x32 C6414 vs C6678 0 Locked

    523 views
    2 replies
    Latest over 13 years ago
    by murad qahwash
  • Not Answered

    Linear Assembly Projects 0 Locked

    583 views
    7 replies
    Latest over 13 years ago
    by Arun
  • Not Answered

    DV8168 dvrlib based on mcfw: custom chain problem - no video detected 0 Locked

    356 views
    1 reply
    Latest over 13 years ago
    by Marat Shchuchinsky
  • Not Answered

    PVR mismatch error for debug flag in Gingerbread 0 Locked

    536 views
    0 replies
    Started over 13 years ago
    by T. Anon
  • Not Answered

    Custom rootfs for AM1808-EVM 0 Locked

    181 views
    0 replies
    Started over 13 years ago
    by Hideki Ishihara
  • Not Answered

    Dual MII ETH (DP83849C) on AM3359 ZCZ 0 Locked

    203 views
    0 replies
    Started over 13 years ago
    by Miha Gostencnik
  • Not Answered

    SPI Drivers on sysbios 0 Locked

    936 views
    1 reply
    Latest over 13 years ago
    by Tom Kopriva
  • Not Answered

    write problem with am335x spi flash 0 Locked

    419 views
    1 reply
    Latest over 13 years ago
    by WRS
  • Not Answered

    McASP on OMAP-L138 0 Locked

    469 views
    3 replies
    Latest over 13 years ago
    by Boris Ruvinsky
  • Not Answered

    Custom kernel on DM816x EVM 0 Locked

    505 views
    1 reply
    Latest over 13 years ago
    by Anil
<>