TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197740 Discussions
  • Not Answered

    Adjust the delay time of DQS and DQ data on DM365 0 Locked

    225 views
    0 replies
    Started over 13 years ago
    by Omin Chou
  • Answered

    light sensor is not working on blaze 0 Locked

    334 views
    3 replies
    Latest over 13 years ago
    by Gina Glaser
  • Not Answered

    How to use BTE to 90-degree rotation? 0 Locked

    330 views
    4 replies
    Latest over 13 years ago
    by li dong
  • Suggested Answer

    Wi-Fi USB dongle for EC7 0 Locked

    399 views
    1 reply
    Latest over 13 years ago
    by Adeneo Embedded support team
  • Not Answered

    AM3892 0 Locked

    536 views
    1 reply
    Latest over 13 years ago
    by Chaitanya Vaddadi
  • Discussion

    Set up a periodic task in SYS/BIOS Locked

    6040 views
    21 replies
    Latest over 13 years ago
    by Todd Anderson78572
  • Not Answered

    Unable to create 'u-boot.img' 0 Locked

    3404 views
    13 replies
    Latest over 13 years ago
    by Anil
  • Not Answered

    EVm6678L NAND Write Fail 0 Locked

    392 views
    4 replies
    Latest over 13 years ago
    by Alberto Chessa
  • Not Answered

    Problem running CaptureTest demo application for DM3730 0 Locked

    309 views
    1 reply
    Latest over 13 years ago
    by Adeneo Embedded support team
  • Not Answered

    Adding file system to nand flash 0 Locked

    111 views
    0 replies
    Started over 13 years ago
    by santosh vastrad
  • Suggested Answer

    NAND Isuue - Number Of Partial Pages 0 Locked

    554 views
    2 replies
    Latest over 13 years ago
    by Adeneo Embedded support team
  • Suggested Answer

    How to use DM3730 DVSDK 0 Locked

    463 views
    1 reply
    Latest over 13 years ago
    by Adeneo Embedded support team
  • Answered

    I need help!!! 0 Locked

    400 views
    4 replies
    Latest over 13 years ago
    by Sandeep Krishnaswamy
  • Answered

    only 120mVpp sound output on dm365evm line out jack 0 Locked

    1021 views
    5 replies
    Latest over 13 years ago
    by MW51194
  • Answered

    Using Linux on DM6446 0 Locked

    733 views
    8 replies
    Latest over 13 years ago
    by std
  • Not Answered

    Gray CCD for DM365 0 Locked

    147 views
    0 replies
    Started over 13 years ago
    by Lin Marsic
  • Not Answered

    Assembler Aborted error: Several Offset out of range errors 0 Locked

    378 views
    0 replies
    Started over 13 years ago
    by Vikram Shivanna
  • Not Answered

    nsf link create fail 0 Locked

    292 views
    1 reply
    Latest over 13 years ago
    by Jacson
  • Not Answered

    fastRTS.lib and cl6x - can I use fastRTS64x.lib for some .obj files and rts.lib for the rest of the code build for a single .out file? 0 Locked

    248 views
    1 reply
    Latest over 13 years ago
    by RandyP
  • Not Answered

    Which DSP to use? 0 Locked

    238 views
    1 reply
    Latest over 13 years ago
    by RandyP
<>