Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
I was trying to watch the training videos contained in the Processor SDK RTOS Getting Started Guide :
Introduction to Processor SDK RTOS Part 1
Introduction to Processor SDK RTOS Part 2
Application Development Using Processor SDK RTOS
It seems…
Part Number: DRA821U Other Parts Discussed in Thread: DRA821
Dear support,
For DDR ECC per-load, we use the BIST engine for SDRAM initilization, but it fails, the following is the registers configured,
Could you help me check whether the configuration…
Part Number: DRA821U
Hi Champs
There're questions about Ethernet Firmware Test on SDK8.1 release.
My customer has tried to activate 4-ports of CPSW-5g on top of SDK 8.1-prebuilt image.
They found issues below. (with followings were executed…
Part Number: TDA4VM Other Parts Discussed in Thread: TI-CGT I have updated the Linux SDK top level Makefile to add my custom firmware for MCU1_0 (MCU R5).
As I understand the path to the ELF image needs to be set as UBOOT_DM in the Makefile. But after…
Part Number: TDA4VM
I am using MCAL CAN driver and able to transmit any message from the TDA4 using MCU MCAN0.
However when I try to receive messages for a particular CAN ID from an external CAN emulator, I am not getting that on the TDA4's MCU MCAN0…
