TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197749 Discussions
  • Not Answered

    VxWorks support for OMAP3530 0 Locked

    345 views
    1 reply
    Latest over 13 years ago
    by BrandonAzbell
  • Answered

    Midas2.0 Custom data 0 Locked

    348 views
    4 replies
    Latest over 13 years ago
    by Mithun k
  • Not Answered

    C6flo example project 0 Locked

    535 views
    6 replies
    Latest over 13 years ago
    by Joe Coombs
  • Not Answered

    incorrect lpsc enums in hardware.h - u-boot for omap-l138 ?? 0 Locked

    234 views
    0 replies
    Started over 13 years ago
    by bowerymarc
  • Not Answered

    DDR performance switching from 4 to 2 chips 0 Locked

    179 views
    2 replies
    Latest over 13 years ago
    by Bill Taboada
  • Not Answered

    Mentor Schematic Symbol for TMS320C6678 0 Locked

    288 views
    1 reply
    Latest over 13 years ago
    by Bill Taboada
  • Answered

    why can't I use the "pldw" assembler instruction on my 3894? 0 Locked

    1417 views
    2 replies
    Latest over 13 years ago
    by robert schulman
  • Not Answered

    Transferring large bursts of data over PCIe link ? 0 Locked

    4032 views
    10 replies
    Latest over 13 years ago
    by Steven Ji
  • Answered

    DMA problems with dm648_h264avc_e_1_14_003 0 Locked

    722 views
    12 replies
    Latest over 13 years ago
    by James Gort
  • Not Answered

    Is There a Load Of Eclipse IDE That Will Actually Run On the BeagleBoard? 0 Locked

    170 views
    1 reply
    Latest over 13 years ago
    by Michael T
  • Discussion

    How to rebuild the hal_eth_dm642.lib Locked

    614 views
    3 replies
    Latest over 13 years ago
    by Steven Connell
  • Answered

    Error connecting to target: TMDXEVM6678L 0 Locked

    490 views
    2 replies
    Latest over 13 years ago
    by Ajay Iyer
  • Answered

    calling GIO_submit using UART with EDMA 0 Locked

    906 views
    3 replies
    Latest over 13 years ago
    by ScottG
  • Answered

    invalid link path 0 Locked

    553 views
    3 replies
    Latest over 13 years ago
    by Joe Coombs
  • Answered

    DSPLIB C64x+: missing objects in LIB 0 Locked

    520 views
    6 replies
    Latest over 13 years ago
    by John Emilian
  • Not Answered

    MicroSD card on OMAP-L138 0 Locked

    275 views
    2 replies
    Latest over 13 years ago
    by Boris Ruvinsky
  • Answered

    SYSBIOS6 on AM3517 0 Locked

    525 views
    7 replies
    Latest over 13 years ago
    by Dennis Nguyen
  • Not Answered

    Power Management for Keystone Devices (SPRABH0) 0 Locked

    349 views
    1 reply
    Latest over 13 years ago
    by Bill Taboada
  • Not Answered

    VLIB_disparity_SAD8 left-> right right->left 0 Locked

    383 views
    0 replies
    Started over 13 years ago
    by Vestaproman
  • Not Answered

    What do I need to connect CCSv4 to DM6467 Target? 0 Locked

    242 views
    3 replies
    Latest over 13 years ago
    by Helmut Forren
<>