Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM623
Hi, TI Expert
[Problem] : We found "MCU_OSC0_XI/MCU_OSC0_OUT" clock starts timing "forward" than VDD_CORE voltage pull high. (Customized board)
Normal timing should be like this chart.
MCU_OSC0_XI/MCU_OSC0_OUT starts after VDD_CORE…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM64B , SK-AM62B
Overview
The UART boot mode available on AM6x processors (and other similar TI devices) is a valuable tool often used during development and board bringup. To load the initial…
Part Number: AM62A7
Hello.
I'm developing custom board which has RMII connection with Ethernet Switch IC. The AM62A and the Ethernet switch IC are connected via MAC-to-MAC mode. The message 'eth0 Link is up' appears, but the ping command fails. I…
Part Number: DP83869
Hi Ethernet Team ,
I have a question on the Xi clock input level.
The DP83869 EPHY IO supply is 3.3V
The Clock buffer supply is 1.8V.
Based on the below, looks like this should not be a issue. Any thoughts please.
Regards…
Part Number: PROCESSOR-SDK-AM62A Other Parts Discussed in Thread: AM62A74 , AM68A , AM62A3 , AM69A I made a model and what to understand how fast it can run on an AI accelerated device like the AM62A.
I see variations in performance based on which scripts…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SK-AM62B , SK-AM62-LP , SK-AM62-SIP , SYSCONFIG ,
Hi TI Experts,
I am starting a new board design and planning to use TI Starter Kit (SK) design files for designing my custom board.…
