TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] SK-AM64B: What is the purpose of --operation=flash-phy-tuning-data ?

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: SK-AM64B Tool/software: Greetings All, In MCU PLUS SDK offering, across Sitara SoCs, one must have come across different configuration files. These configuration files are located inside the directory: MCU_PLUS_SDK_INSTALL_PATH\tools…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM69A: BOOTING FROM EMMC WITHOUT SD CARD

    Gokul Praveen
    Gokul Praveen
    Part Number: AM69A Other Parts Discussed in Thread: AM69 Tool/software: How to boot from eMMC without SD card?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: Undeclared Identifier for MCU GPIO Interrupt Routers

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG Tool/software: I am trying to upgrade my project to use the new MCU+ SDK 10.1 and I'm running into a compilation error saying that the interrupt router number is undeclared. This…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x / AM243x (ALV) / AM335x Design Recommendations / Custom board hardware design - Schematics review checklists

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62L Tool/software: Hi Board designers The AM64x, AM62x, AM62Ax, AM62D-Q1, AM62Px and AM62L custom board Schematic review Checklist application note provides a supplemental design check…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: Deploy MMYOLO on AM62A, YOLOV8 nano as example.

    Adam Hua
    Adam Hua
    Part Number: AM62A7-Q1 Tool/software: MMYOLO is an open source repo for quick yolo model evaluation. Deployment MMYOLO on TI processor like AM6x or TDAx requires some modifications on this repo. This FAQ uses yolov8 as example to demonstrate how to…
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to SysConfig-PinMux IOSET and Voltage Conflict

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62P Tool/software: Hi TI Experts, I see IOSET option and Voltage Conflict indication while using SysConfig-PinMux. Can you provide additional inputs on the IOSET and Voltage configuration
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: Incorrect auto-generated MAC port 2 PHY configuration

    Nitika Verma
    Nitika Verma
    Part Number: SK-AM64B Other Parts Discussed in Thread: DP83869 , SYSCONFIG Tool/software: The two Ethernet Ports on SK-AM64x are connected to two separate Gigabit Ethernet PHY Transceivers DP83867. On enabling MAC Port 2 in SK-AM64x networking…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to passive components values, tolerance, voltage rating

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, 1. In the SK/EVM i see 49.9K resistor used. Can i use a standard value instead 2. In the SK/EVM i see a number of resistors used with 1% tolerance for pullups and series resistors. Can i use standard…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design – Queries related to Residual Voltage, Detection and supply decay

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TPS65219 , TPS6594-Q1 , AM62P Tool/software: HI TI experts, I have the below queries related to residual voltage 1. What are the causes for Residual Voltage 2. Effect of Residual Voltage on…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: SDIO driver strength change

    Biao Li
    Biao Li
    Part Number: AM62A7-Q1 Other Parts Discussed in Thread: AM62A7 Tool/software: Hi Expert, Customer was doing EMC test, it was found that the EMMC CLOCK exceeded the standard by 10dB at 1.8GHz and 1.6GHz. Can the output strength capability of the…
    • 9 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198401 Discussions
  • Answered

    DM3730, GStreamer, ffmpeg 0 Locked

    498 views
    3 replies
    Latest over 13 years ago
    by Bob Lee
  • Not Answered

    C6748 IFFT data error and printf/LOG_printf 0 Locked

    475 views
    4 replies
    Latest over 13 years ago
    by Patrick Emer
  • Answered

    McBSP CSL macros no longer working - CCS3.3 to CCS5.1 0 Locked

    393 views
    1 reply
    Latest over 13 years ago
    by Robert Wolfe
  • Not Answered

    SharedMem question 0 Locked

    150 views
    1 reply
    Latest over 13 years ago
    by RandyP
  • Not Answered

    Restart ARM when DSP keeps running 0 Locked

    154 views
    1 reply
    Latest over 13 years ago
    by serdar
  • Answered

    omap3evm browser crash? 0 Locked

    902 views
    4 replies
    Latest over 13 years ago
    by Satish Patel
  • Not Answered

    Problem booting TI_Android_GingerBread_2_3_4_DevKit_2_1 on Beagleboard Xm Rev C 0 Locked

    3073 views
    18 replies
    Latest over 13 years ago
    by Satish Patel
  • Not Answered

    Beagleboard Ubuntu SGX compile and setup failed 0 Locked

    226 views
    1 reply
    Latest over 13 years ago
    by Prabindh Sundareson
  • Answered

    Can't boot with dm8168 0 Locked

    523 views
    5 replies
    Latest over 13 years ago
    by echo yang
  • Answered

    AM35xx LVCMOS I/O capacitance (3pF) 0 Locked

    314 views
    3 replies
    Latest over 13 years ago
    by peaves
  • Not Answered

    Emulator GEL file 0 Locked

    253 views
    1 reply
    Latest over 13 years ago
    by Daniel Allred
  • Answered

    Mcasp can't transfer data when hard disk or nand flash write and read data 0 Locked

    296 views
    1 reply
    Latest over 13 years ago
    by kcastille
  • Answered

    SDK 5.02 vs 5.03: AAC Encoder OpenMax app question 0 Locked

    372 views
    2 replies
    Latest over 13 years ago
    by Juan Solis
  • Answered

    OMAP-L132 and Ethernet 0 Locked

    281 views
    1 reply
    Latest over 13 years ago
    by jc-ti
  • Discussion

    Problem in using C6748 RTFS Locked

    631 views
    9 replies
    Latest over 13 years ago
    by Steven Connell
  • Answered

    L137 SPI drivers 0 Locked

    480 views
    6 replies
    Latest over 13 years ago
    by Keith Bartels
  • Not Answered

    Complex FFT execution Time on DM8148 0 Locked

    312 views
    1 reply
    Latest over 13 years ago
    by Rahul Prabhu
  • Answered

    How to change compiling paths in makefile? 0 Locked

    364 views
    3 replies
    Latest over 13 years ago
    by janet
  • Not Answered

    How to config DM368 YCC16 digital video output to connect with HDMI TX SiI9134? 0 Locked

    264 views
    0 replies
    Started over 13 years ago
    by Baijian Liao
  • Answered

    how many memory does IPC need? 0 Locked

    269 views
    1 reply
    Latest over 13 years ago
    by judahvang
<>