TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198320 Discussions
  • Not Answered

    Putting an OMAP or AM Sitara onto a PCIe card 0 Locked

    187 views
    1 reply
    Latest over 14 years ago
    by Luke Leighton
  • Answered

    ADC over GPMC for the OMAP3530 0 Locked

    746 views
    7 replies
    Latest over 14 years ago
    by BrandonAzbell
  • Not Answered

    L138 USB20 endpoint arbitration 0 Locked

    494 views
    7 replies
    Latest over 14 years ago
    by Kiung Chung Wong
  • Not Answered

    question on kalman filter 4*6 in Vlib 0 Locked

    552 views
    1 reply
    Latest over 14 years ago
    by Senthil Kumar Yogamani
  • Answered

    Openmax/syslink error in RDK 00.07.00.01 of 816x DVR reference. 0 Locked

    1270 views
    11 replies
    Latest over 14 years ago
    by Anshuman Saxena
  • Answered

    sys/bios on 28035 with ccsv4 compile error 0 Locked

    497 views
    2 replies
    Latest over 14 years ago
    by judahvang
  • Not Answered

    cmemk.ko, irqk.ko, dm365mmap.ko, edmak.ko 0 Locked

    346 views
    0 replies
    Started over 14 years ago
    by Charvi Mehta
  • Not Answered

    Clock timing for 8.4 inch SHARP LCD at 41.538Mhz clock 0 Locked

    174 views
    0 replies
    Started over 14 years ago
    by Arockia winiston
  • Not Answered

    useHeap didn't work on DM368 0 Locked

    525 views
    4 replies
    Latest over 14 years ago
    by Robert Tivy
  • Not Answered

    I Want to change VPSS Clock frequency in DM6446... 0 Locked

    1010 views
    13 replies
    Latest over 14 years ago
    by Arockia winiston
  • Not Answered

    problem with Programing IBL Configuration 0 Locked

    1163 views
    3 replies
    Latest over 14 years ago
    by gang
  • Not Answered

    DM3730 not booting from SD card 0 Locked

    438 views
    1 reply
    Latest over 14 years ago
    by Tomas Klas
  • Not Answered

    DM3730:Does the DSP/BIOS target have any Mcbsp device driver? 0 Locked

    303 views
    0 replies
    Started over 14 years ago
    by frank ayanb
  • Not Answered

    Gigabit Network Driver demo for TMDXEVM6467T 0 Locked

    201 views
    0 replies
    Started over 14 years ago
    by seed.zhao
  • Not Answered

    Issue with configuring GPMC read and write related signals - Read signals don't correspond to register settings. OMAP2430 0 Locked

    219 views
    0 replies
    Started over 14 years ago
    by Rajath Shetty
  • Not Answered

    cmemk.ko kernel problem 0 Locked

    366 views
    4 replies
    Latest over 14 years ago
    by Niclas
  • Not Answered

    No console after Linux uncompress on the Mistral OMAP3530 EVM 0 Locked

    583 views
    8 replies
    Latest over 14 years ago
    by Vincent Ajit
  • Answered

    H.264 encoder yet uses DSP? 0 Locked

    288 views
    2 replies
    Latest over 14 years ago
    by Joern
  • Discussion

    v4l2 display driver Locked

    379 views
    4 replies
    Latest over 14 years ago
    by moidin suzan
  • Not Answered

    Regarding usage of new version linux 0 Locked

    177 views
    0 replies
    Started over 14 years ago
    by VENKAT47948
<>