Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: PROCESSOR-SDK-DRA8X-TDA4X
I see different processing cores available in the Jacinto 7 device, which processing cores can I use to configure the Gigabit Ethernet Switch (CPSW)?
Part Number: PROCESSOR-SDK-DRA8X-TDA4X
Dear Users,
The Jacinto 7 FAQs are now made available.
To navigate FAQs for a specific module, please follow the link below:
All
Boot
C7x
DMSC
Graphics
Imaging
MCAL
Networking
OpenVX
QNX…
Other Parts Discussed in Thread: TDA4VM , DRA829V I tried to request some service from System Firmware through a TISCI call. I received a NACK response or no response at all. How can I debug this?
Part Number: PROCESSOR-SDK-DRA8X-TDA4X
I have a Jacinto 7 EVM and I’ve built code for many of the cores using a DRA8x / TDA4x Software Development Kit (SDK). But, I’m not sure how to get all the cores loaded & running at the same time from Code Composer…
Part Number: PROCESSOR-SDK-DRA8X-TDA4X
I see that TI supports OpenVX, but I don't see an openvx folder in the SDK, only a tiovx. Is this the same as OpenVX or are there differences?
Part Number: PROCESSOR-SDK-DRA8X-TDA4X
What are the different layers that go into AUTOSAR, what is the functionality of each layer, and how does MCAL relate to the framework as a whole?