TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198583 Discussions
  • Not Answered

    Why my video on the display is black and white? has anybody meet it ? 0 Locked

    204 views
    0 replies
    Started over 14 years ago
    by jian wang73298
  • Answered

    DM368 h264 encoder makefile error 0 Locked

    641 views
    2 replies
    Latest over 14 years ago
    by Veeranna Hanchinal
  • Suggested Answer

    Filters on 3206748 0 Locked

    193 views
    1 reply
    Latest over 14 years ago
    by dabuan
  • Not Answered

    Error in minicom uboot configuration script 0 Locked

    1116 views
    3 replies
    Latest over 14 years ago
    by Kirill Brilliantov
  • Not Answered

    IPC Syslink 0 Locked

    411 views
    3 replies
    Latest over 14 years ago
    by Robert Tivy
  • Not Answered

    How to let a PCI Interrupt trigger a HWI on DSP? 0 Locked

    201 views
    1 reply
    Latest over 14 years ago
    by MarcPyne
  • Not Answered

    AM1808 no RGB(LCD) out 0 Locked

    221 views
    3 replies
    Latest over 14 years ago
    by jc-ti
  • Not Answered

    boot device 0 Locked

    154 views
    1 reply
    Latest over 14 years ago
    by MarcPyne
  • Answered

    BT.656 Over Cable 0 Locked

    288 views
    1 reply
    Latest over 14 years ago
    by Viet Dinh
  • Answered

    Programming SPI Flash on OMAP-L137 EVM 0 Locked

    511 views
    4 replies
    Latest over 14 years ago
    by Norman Wong
  • Not Answered

    DM36x DDR2 problem 0 Locked

    147 views
    1 reply
    Latest over 14 years ago
    by Marcus Cooksey
  • Not Answered

    ezdsp 0 Locked

    264 views
    6 replies
    Latest over 14 years ago
    by seeni vasan
  • Answered

    C6678 DDR3 Track Impedances 0 Locked

    347 views
    1 reply
    Latest over 14 years ago
    by Bill Taboada
  • Answered

    Mapping of CCDC11-0 inputs to H3A inputs 0 Locked

    162 views
    3 replies
    Latest over 14 years ago
    by Gang Hua
  • Answered

    Help 0 Locked

    371 views
    1 reply
    Latest over 14 years ago
    by Prasad Joshi
  • Answered

    Shared variables, real time issue 0 Locked

    533 views
    7 replies
    Latest over 14 years ago
    by Daniel Allred
  • Not Answered

    c66x binary compatible? 0 Locked

    409 views
    1 reply
    Latest over 14 years ago
    by Chad Courtney
  • Not Answered

    DM365 GPIO Interrupt issue 0 Locked

    347 views
    1 reply
    Latest over 14 years ago
    by Marcus Cooksey
  • Not Answered

    I2s and DMA 0 Locked

    150 views
    1 reply
    Latest over 14 years ago
    by Chuan Chen76573
  • Suggested Answer

    start 0 Locked

    213 views
    1 reply
    Latest over 14 years ago
    by DanRinkes
<>