Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: J784S4XEVM This are patches for backporting tidl software layer from 9.0 SDK to 8.6 SDK.
Please refer this FAQ to download and apply patches, the detailed documentation is available soon as part of App Note, and will be linked here.
Please…
Part Number: J721EXCPXEVM This are patches for backporting tidl software layer from 9.0 SDK to 8.6 SDK.
Please refer this FAQ to download and apply patches, the detailed documentation is available soon as part of App Note, and will be linked here. …
Part Number: AM62A3
Hi all,
the AM62A datasheet shows a typical value of 25MHz for the crystal on MCU_OSC0 and no mention of additional clock speed modes.
The TRM in Fig 6-84 shows 24/25/26MHz options for the main crystal.
Are 24MHz and…
Part Number: J721S2XSOMXEVM Other Parts Discussed in Thread: TDA4VL , TDA4VM
When using J721E/TDA4VM with TI's CPB (common processor board), all PCIe slots are functional. However, when I switch to J721S2/TDA4VL SOM board and use the same CPB, only…
Part Number: AM6442 Other Parts Discussed in Thread: DP83869
Hi Team ,
we are developing a hardware based on AM6442ASFGGAALV. We have following initial queries .Please help
We need a 1Gbps ethernet phy which can support both copper and OFC cables…
Part Number: SK-AM68 I want a minimal configuration to run graphics applications using Weston since the full SDK image is not necessary for the development of my application. Currently, when I try to boot the core-image-weston as is from the Yocto build…
Other Parts Discussed in Thread: SK-AM62 , SK-AM62-LP , SK-AM62A-LP AM62x/AM62Ax Boot ROM supports booting from (x)SPI-NOR and Serial-NAND. Please refer to AM62x/AM62Ax TRM "Chapter 5 Initialization" for details. The OSPI-NOR and OSPI-NAND are installed…
Part Number: AM62A7-Q1 Other Parts Discussed in Thread: AM62P
Hello Experts, In the TRM, there is following description >These bits do not apply to "I2C OD FS" buffer types as these IOs do not have internal pull registers. >The MCU_I2C0 and WKUP_I2C0…
