TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198182 Discussions
  • Not Answered

    Pass along MV/SAD information outside IPNC? 0 Locked

    593 views
    6 replies
    Latest over 14 years ago
    by mahendra kumar
  • Not Answered

    McBSP data rate 0 Locked

    185 views
    1 reply
    Latest over 14 years ago
    by PaulM
  • Discussion

    Interrupt on TMS320VC5505-eZDSp Locked

    238 views
    0 replies
    Started over 14 years ago
    by Ashwin Panchal
  • Not Answered

    Building DM365 IPNC(ECDK) with kernel linux-staging kernel(2.6.32) and dvsdk_3_10_00_19 0 Locked

    284 views
    1 reply
    Latest over 14 years ago
    by Sithara T S
  • Not Answered

    AV_SERVER in DM365_IPNC(ECDK) Board and dvsdk_2_10_01_18 with linux-staging kernel of 2.6.32 0 Locked

    340 views
    1 reply
    Latest over 14 years ago
    by Sithara T S
  • Answered

    Slices per frame on DM6467 Baseline Profile Encoder 0 Locked

    238 views
    1 reply
    Latest over 14 years ago
    by Kapil Ahuja
  • Not Answered

    Getting Started with DaVinci 0 Locked

    25617 views
    25 replies
    Latest over 14 years ago
    by helen white
  • Not Answered

    Editing DSPlink sample application 0 Locked

    146 views
    1 reply
    Latest over 14 years ago
    by Deepali Uppal
  • Answered

    C6472 SYSCLK for timers 0 Locked

    249 views
    2 replies
    Latest over 14 years ago
    by Eddie3909
  • Not Answered

    OMAP35x MMC (eMMC) Boot when using TPS65930 PMIC 0 Locked

    334 views
    1 reply
    Latest over 14 years ago
    by BrandonAzbell
  • Not Answered

    How to use TPS650732 series PMIC to power up DM368? 0 Locked

    315 views
    0 replies
    Started over 14 years ago
    by YI HAO
  • Not Answered

    Optimizing Assembly Code through Software Pipelining 0 Locked

    345 views
    4 replies
    Latest over 14 years ago
    by RandyP
  • Answered

    Ramdisk Test on DM6467 0 Locked

    380 views
    1 reply
    Latest over 14 years ago
    by Vincent 51111
  • Not Answered

    Read from Flash memory 0 Locked

    155 views
    1 reply
    Latest over 14 years ago
    by RandyP
  • Not Answered

    Video display delay in dm365 decode 0 Locked

    979 views
    8 replies
    Latest over 14 years ago
    by Jing1
  • Suggested Answer

    IQmath - inline mathematical functions 0 Locked

    866 views
    6 replies
    Latest over 14 years ago
    by HRi
  • Answered

    AM1808 LCD Controller Interface for 8 Bit RGB Mode 0 Locked

    1113 views
    4 replies
    Latest over 14 years ago
    by Soren Steen Christensen
  • Not Answered

    how to use usb communicating with PC in C6747 0 Locked

    4212 views
    33 replies
    Latest over 14 years ago
    by M.Naruoka39592
  • Not Answered

    C64x+ DSP L1, L2 memory configurati 0 Locked

    191 views
    0 replies
    Started over 14 years ago
    by diko
  • Answered

    JTAG emulator problem with DM368 0 Locked

    3566 views
    6 replies
    Latest over 14 years ago
    by Rain Peng
<>