TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] J721EXSOMXEVM: How to work around errata i2086 for PCIe switches and multifunction devices for J721E/TDA4VM/DRA829?

    Takuma Fujiwara
    Takuma Fujiwara
    Part Number: J721EXSOMXEVM Other Parts Discussed in Thread: TDA4VM , TDA4VL , TDA4VH , DRA829 There is a known errata for J721E/TDA4VM/DRA829 where connecting a PCIe switch, or multi-function PCIe device would cause a system abort. This issue only affects…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: CAN Profiling Application failed to operate in Tx only or External Loopback and Polling mode or interrupt mode.

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Hi, Can you provide patch to fix the issue on SDK 8.6 ? Regards Tarun Mukesh
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] How do I bring/brought up Ethernet interfaces for Main Domain CPSWnG in Linux from SDK Version 9.0 and above?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , TDA4VH , TDA4VL How do I bring/brought up Ethernet interfaces for Main Domain CPSWnG in Linux from SDK Version 9.0 and above?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] Setting up Auto Exposure (AE) for your image sensor with TDA4/AM6xA ISP (VPAC)

    Gang Hua
    Gang Hua
    How can I set up AE for an camera/sensor with TDA4/AM6xA ISP (VPAC)?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] Where can i find MCAL configurator package and EB Tresos studio for Jacinto devices ?

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customers typically asks below 2 queries on MCUSW Configurator 1. How to get access for MCAL Configurator package "MCUSW_XX_YY_ZZ_BB_CONFIG-windows-installer.exe" ? 2. How to request an EB Tresos license for MCUSW…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] AM6412: AM64x SPI D0 and D1 - MISO/MOSI

    Parthan Mohan
    Parthan Mohan
    Part Number: AM6412 Hi, As per the AM64x Sitara Processors datasheet, both MCSPI and MCU_MCSPI D0 and D1 signals defined as IO pin type We need to develop a product based on the AM6412 processor While interfacing any slaves devices with the AM6412…
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] J721S2XSOMXEVM: How to enable main domain watchdog?

    Keerthy J
    Keerthy J
    Part Number: J721S2XSOMXEVM Other Parts Discussed in Thread: TDA4VM The j721e/TDA4VM has SOC watchdog enabled. How to enable the same on J721s2?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] DCC Tuning Tool V3.2 for VPAC on TDA4x and AM6xA Devices

    Gang Hua
    Gang Hua
    Hi everyone, DCC Tuning Tool V3.2 for TDA4x and AM6xA has been released in 09/2024. You may find it now in your secure resource section on ti.com. If you have no access or expired access, you may apply here -- http://www.ti.com/drr/opn/ADAS-SW-IMAGING…
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to enable main domain watchdog?

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Other Parts Discussed in Thread: TDA4VM The j721e/TDA4VM has SOC watchdog enabled. How to enable the same on J784s4?
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
  • [FAQ] AM64X/AM62X: How do I route the same GPIO bank interrupts to different destination cores?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 How do I route the same GPIO bank interrupts to different destination cores? Example: I want to route the GPIO0_37 pin interrupt to R5F0_0 and the GPIO0_38 pin interrupt to R5F0_1. when I was selecting the above pin combination…
    • Answered
    • over 2 years ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198112 Discussions
  • Answered

    AAC Encoder on 5509A - need recommendations for how to effectively use off chip memory with this algo 0 Locked

    491 views
    7 replies
    Latest over 14 years ago
    by James56380
  • Not Answered

    Conflict problem of ALG_jpgDecRun and DRV_frameCopy on DM365 in AV_SERVER structure 0 Locked

    310 views
    2 replies
    Latest over 14 years ago
    by Parry Huang
  • Not Answered

    creating /dev/video0 0 Locked

    959 views
    5 replies
    Latest over 14 years ago
    by Woody Douglass
  • Not Answered

    DM365: Image data transfer over USB 0 Locked

    398 views
    4 replies
    Latest over 14 years ago
    by swami
  • Not Answered

    Drivers for TNET1130 WLAN Adapter 0 Locked

    2789 views
    3 replies
    Latest over 14 years ago
    by Stuart Aldridge
  • Answered

    can't modify dynamic params after create 0 Locked

    426 views
    6 replies
    Latest over 14 years ago
    by BJ Opp
  • Answered

    ILTiming on Windows Embedded Compact 7 0 Locked

    1534 views
    5 replies
    Latest over 14 years ago
    by Jatin Jain
  • Answered

    Disabling PING in STATUS stage of USB 0 Locked

    500 views
    2 replies
    Latest over 14 years ago
    by Zegeye Alemu
  • Not Answered

    Address calculation !!!??? CE2 and CE3 0 Locked

    293 views
    1 reply
    Latest over 14 years ago
    by tlee
  • Not Answered

    Bridging uart to eth0 0 Locked

    147 views
    0 replies
    Started over 14 years ago
    by David Saar
  • Suggested Answer

    How to create and setting Timer interrupt vectors for TMS320VC5505 eZDSP USB Stick? 0 Locked

    470 views
    3 replies
    Latest over 14 years ago
    by Christos Nikolaou12204
  • Answered

    SWI post before function completes C5510 0 Locked

    1318 views
    7 replies
    Latest over 14 years ago
    by David Friedland
  • Answered

    Graphics Library for DM6437 0 Locked

    280 views
    5 replies
    Latest over 14 years ago
    by Prateek Bansal
  • Answered

    NFS problem 0 Locked

    666 views
    3 replies
    Latest over 14 years ago
    by Michael Mayercik
  • Not Answered

    5510 HPI download 0 Locked

    248 views
    1 reply
    Latest over 14 years ago
    by TommyG
  • Suggested Answer

    C6Run for WinCE? 0 Locked

    263 views
    2 replies
    Latest over 14 years ago
    by Rahul Prabhu
  • Not Answered

    5509A - DMA_DMACCR_EN_STOP/START 0 Locked

    192 views
    1 reply
    Latest over 14 years ago
    by TommyG
  • Not Answered

    Is DaVinci good for this project? 0 Locked

    630 views
    11 replies
    Latest over 14 years ago
    by Paul.Yin
  • Answered

    How OMAP-L138 assign peripherals to ARM or DSP? 0 Locked

    517 views
    5 replies
    Latest over 14 years ago
    by tlee
  • Not Answered

    Basic Code Composer project for 5510a 0 Locked

    340 views
    3 replies
    Latest over 14 years ago
    by TommyG
<>