TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197700 Discussions
  • Not Answered

    Watchdog timer reset issue in DM648 0 Locked

    1476 views
    15 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    Access CMEM from the DSP on DM6446 0 Locked

    566 views
    7 replies
    Latest over 16 years ago
    by Chris Ring
  • Discussion

    DSP/BIOS Interrupt Configuration (C6455) Locked

    2022 views
    3 replies
    Latest over 16 years ago
    by Brad Griffis
  • Not Answered

    How to use YI[7:0]&CI[7:0] as two separate vedio input port? 0 Locked

    272 views
    3 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    L137 SPI and >16-bit transfers Locked

    358 views
    3 replies
    Latest over 16 years ago
    by Bobby McGoldrick
  • Not Answered

    ethernet sample code 0 Locked

    804 views
    18 replies
    Latest over 16 years ago
    by jawad
  • Discussion

    CODEC Engine Customer Feedback requested Locked

    195 views
    0 replies
    Started over 16 years ago
    by Juan Gonzales
  • Not Answered

    CODEC Engine Customer Feedback requested 0 Locked

    155 views
    0 replies
    Started over 16 years ago
    by Juan Gonzales
  • Answered

    omapL137 's U-boot 0 Locked

    288 views
    3 replies
    Latest over 16 years ago
    by Levone
  • Not Answered

    DSP/BIOS Flash Boot for C6424 0 Locked

    514 views
    3 replies
    Latest over 16 years ago
    by TimHarron
  • Discussion

    OMAP-L137 ARM Interrupts Locked

    2018 views
    12 replies
    Latest over 16 years ago
    by Kevin Halloran
  • Discussion

    Code composer error Locked

    294 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
  • Discussion

    Difference between EHPI and HPI Locked

    594 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
  • Discussion

    What DaVinci processor can do real time MPEG-2 720p60,1080i60 and 1080p24 HD encoding? Locked

    473 views
    3 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Input 720x480, output 360x240 ? Locked

    345 views
    4 replies
    Latest over 16 years ago
    by Igor
  • Not Answered

    OMAP3530 sys_nreswarm signal problem 0 Locked

    313 views
    4 replies
    Latest over 16 years ago
    by ler
  • Not Answered

    about request_buffer:not enough memory issue? 0 Locked

    430 views
    3 replies
    Latest over 16 years ago
    by winkyxiao
  • Discussion

    Simultaneous Tx and Rx data transfer using USB Locked

    718 views
    5 replies
    Latest over 16 years ago
    by swami
  • Discussion

    DSP training Locked

    263 views
    0 replies
    Started over 16 years ago
    by chris.
  • Discussion

    USB communication with Jtag Locked

    468 views
    5 replies
    Latest over 16 years ago
    by lester davis
<>