TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM6442: MCU_OSC0 Crystal Circuit Requirements

    Guillaume Henri
    Guillaume Henri
    Part Number: AM6442 Tool/software: Dear Sitara HW champs, In the Table “6-19. MCU_OSC0 Crystal Circuit Requirements” in the AM64x datasheet, it is specified the following : . When not using the RGMII and/or RMII interfaces, then +/-100 ppm Xtal…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: Data Verification Error while loading the program on M4F core

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Tool/software: I am trying to load the SDK example code to AM62x/AM64x board, but I am facing an issue while loading the program into it as shown in the below screenshot. Can you please help to resolve the above error…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62A / AM62D-Q1 / AM62P / AM62L / AM64x / AM243x Design Recommendations / Custom board hardware design - Custom Board Schematics Self Review

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TMDS64EVM , SK-AM64B , SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP , , SK-AM62A-LP , AM62P , SK-AM62P-LP Tool/software: HI TI experts, We are currently designing a custom board leveraging…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: Patches and scripts for the SRV optimization App note

    Nikhil Dasan
    Nikhil Dasan
    Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM Tool/software: Links for the patches for the SRV optimization App note
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: MDIO change in SR2.0

    Biao Li
    Biao Li
    Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM Tool/software: Hi Expert, My customer Motovis report an issue about ethernet link down issue, customer have catch the MDIO using the Logic analysis, they find there is some difference…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625: MCSPI MISO MOSI IDENTIFICATION

    Paul Nwoko
    Paul Nwoko
    Part Number: AM625 Tool/software: Hi Ti Experts, I am designing a custom board for the AM6254 SoC and trying to connect an SPI peripheral to the AM6254 SPI interface. I intend to use MCU_SPI1 Channel but I am not sure which one is MISO and MOSI…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AP-Q1: How to Set PCIe0 Transmitter De-emphasis

    Kevin Peng
    Kevin Peng
    Part Number: TDA4AP-Q1 Tool/software: Hi TI Experts, Customer is working on TDA4AP SDK10.0. They are using SPL boot. They want to change the De-emphasis to be -3.5dB for PCIe0 for 5.0GT/s to minimize reflection. Please see the below description…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62X/AM62Ax/AM62Px: What to do if Linux fails to initialize remoteproc with DM R5F?

    Nick Saulnier
    Nick Saulnier
    I am using a processor with a DM R5F (AM62x, AM62Ax, AM62Px). I am using SDK 9.2.1 or SDK 10.0. The Device Manager (RM) R5F core is listed in the Linux devicetree, so Linux should use the remoteproc driver to attach to the DM R5F during Linux boot time…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM69: How to stream from CSI sensor and USB camera to display using GStreamer?

    Fabiana Jaimes
    Fabiana Jaimes
    Part Number: SK-AM69 Other Parts Discussed in Thread: SK-AM68 , AM67 , SK-TDA4VM Tool/software: Hi, I have a Starter Kit (SK) Edge AI device with a CSI sensor connected and would like to stream to my display. I have enabled the sensor by following…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] : How to test ECC for R5F Cache Memories on AM6x/AM243 devices.

    Nihar Potturu
    Nihar Potturu
    Part Number: SK-AM62B-P1 Tool/software: Is ECC (SEC/DED) testing possible on R5F internal cache memories? If yes, please provide the steps to do so.
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197991 Discussions
  • Answered

    PSP example build errors 0 Locked

    975 views
    8 replies
    Latest over 16 years ago
    by Mariana
  • Not Answered

    [OMAP3530] Unable to open Engine...Problem in Loading DSP.... Memory configuration for servers... 0 Locked

    253 views
    0 replies
    Started over 16 years ago
    by M BHARATH
  • Discussion

    Need help with hardware-programming Locked

    270 views
    4 replies
    Latest over 16 years ago
    by SabineKäß
  • Not Answered

    [OMAP3525] OMAP VDD1, VDD2 Supplies 0 Locked

    270 views
    0 replies
    Started over 16 years ago
    by Yuvaraj Velumani
  • Not Answered

    How to change the Codec Combo path with the DM6467 0 Locked

    192 views
    0 replies
    Started over 16 years ago
    by CCH
  • Suggested Answer

    DM355 DDRPHYCTL1[31:17] DLL settings 0 Locked

    263 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Suggested Answer

    Recommendations for 3.0V power rails on DM355 0 Locked

    192 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Setting FB devices in the DM355 (fbset) 0 Locked

    515 views
    4 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Suggested Answer

    OMAP-L137 EDMA - What is the best way to start? 0 Locked

    362 views
    1 reply
    Latest over 16 years ago
    by Devin
  • Not Answered

    Which IDE should I select to develop ARM side of 6446 in Linux system? 0 Locked

    871 views
    13 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Suggested Answer

    DM644x VPBE and DCLK 0 Locked

    271 views
    4 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Suggested Answer

    OMAP l137 EVM power question 0 Locked

    265 views
    6 replies
    Latest over 16 years ago
    by PJD
  • Suggested Answer

    OMAP - AUTOIDLE bit 0 Locked

    380 views
    1 reply
    Latest over 16 years ago
    by Shobhraj Singh
  • Not Answered

    vlynq support 0 Locked

    238 views
    0 replies
    Started over 16 years ago
    by lletiernn
  • Suggested Answer

    OMAP Power Domain 0 Locked

    561 views
    2 replies
    Latest over 16 years ago
    by Shobhraj Singh
  • Suggested Answer

    general problem with GPIO as outputs 0 Locked

    343 views
    2 replies
    Latest over 16 years ago
    by burchmere
  • Suggested Answer

    Question about how to extend the network port on the DM6437 0 Locked

    182 views
    1 reply
    Latest over 16 years ago
    by MattLipsey
  • Not Answered

    [OMAP3530] Codec Engine : Errors while building .x64P on DSP server using only .l64P (Codec Package excludes source files) 0 Locked

    303 views
    1 reply
    Latest over 16 years ago
    by Chris Ring
  • Not Answered

    about profile and cachetune 0 Locked

    150 views
    1 reply
    Latest over 16 years ago
    by Manivannan E
  • Not Answered

    Quick question about CCS: how to work with 2 targets without adding/deleting the connection every time 0 Locked

    145 views
    0 replies
    Started over 16 years ago
    by James Thorton
<>