TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198205 Discussions
  • Not Answered

    Update the SDK component 0 Locked

    174 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    about ndk??? 0 Locked

    392 views
    5 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Not Answered

    Code Compilation - Timing Problems 0 Locked

    172 views
    1 reply
    Latest over 16 years ago
    by BrandonAzbell
  • Discussion

    [C6713] Analog Output Question Locked

    2569 views
    23 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Not Answered

    EDMA in the DSP side codec.. 0 Locked

    243 views
    2 replies
    Latest over 16 years ago
    by Gunjan
  • Not Answered

    Make XDAIS sample work with codec engine 0 Locked

    256 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    bom needed for c54cst 0 Locked

    298 views
    1 reply
    Latest over 16 years ago
    by TommyG
  • Answered

    How do I read VERSION? 0 Locked

    483 views
    5 replies
    Latest over 16 years ago
    by j p
  • Not Answered

    CCS slowdown when reloading with register windows displayed 0 Locked

    219 views
    2 replies
    Latest over 16 years ago
    by MattLipsey
  • Not Answered

    H264 on DM6446 testing 0 Locked

    185 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    How to access pixels in a frame on DM6446 0 Locked

    289 views
    3 replies
    Latest over 16 years ago
    by LorryAstra
  • Answered

    how to manually map c64+ interrupt service routines 0 Locked

    322 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    request for help... it is very urgent...please help.... 0 Locked

    647 views
    6 replies
    Latest over 16 years ago
    by MANIKANDAN NAGARAJAN
  • Not Answered

    GUI Developement 0 Locked

    256 views
    4 replies
    Latest over 16 years ago
    by Clay Montgomery
  • Answered

    non-multiplexed device in GPMC space 0 Locked

    253 views
    1 reply
    Latest over 16 years ago
    by BrandonAzbell
  • Not Answered

    Question: Build codec example in Codec Engine. 0 Locked

    309 views
    2 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Montavista 5 apt-get not installed?? 0 Locked

    413 views
    0 replies
    Started over 16 years ago
    by MRI
  • Not Answered

    VIDENC1_create returns NULL when exteneded parameters are used. 0 Locked

    407 views
    1 reply
    Latest over 16 years ago
    by Chris Ring
  • Not Answered

    Something about devRocket 0 Locked

    343 views
    3 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    [OMAP3530] linux side EDMA configuration... 0 Locked

    180 views
    1 reply
    Latest over 16 years ago
    by Chris Ring
<>