TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Design Recommendations / Custom board hardware design – common queries for PMIC TPS65224-Q1

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62P Other Parts Discussed in Thread: TPS65224-Q1 , TPS65219 , , TPS65224 , AM62A7 , AM62A3 , AM62A7-Q1 , AM62A3-Q1 , USB2ANY , AM6442 Tool/software: HI Board designers, I am designing my board using TPS65224-Q1 PMIC Are there some…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Design Recommendations / Custom board hardware design – common queries for PMIC TPS6593

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62A74 Other Parts Discussed in Thread: TPS6594-Q1 , TPS65224 , TPS6593-Q1 Tool/software: HI Board designers, I am designing my board using TPS6593 PMIC Are there some common recommendation or observations that i should be aware…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP Design Recommendations / Custom board hardware design – Common queries for PMIC TPS65219 and PDN

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TPS65219 , TPS6521905 , TPS65215 , AM2434 , TPS65220 , AM6421 Tool/software: HI Board designers, I am designing my board using TPS65219. Are there some common recommendation or observations that…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: Custom board hardware design – Connection recommendations for RSVD pins

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, I see some of the processor pins named RSVD. Are there some recommendations to be followed during custom board design.
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP Custom board hardware design – Queries regarding crystal (MCU_OSC0) Start-up Time

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM6442 , , AM62P , SYSCONFIG Tool/software: Hi TI Experts, I have a question about "Figure 7-16. MCU_OSC0 Start-up Time" from the datasheet. Here it looks like that MCU_OSC0 is only allowed to…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM3357: ADC AIN input for AM3357 (also applies to AM3352 , AM3354 , AM3356 ,AM3358 , AM3359)

    takahiro higuchi
    takahiro higuchi
    Part Number: AM3357 Tool/software: Hi team, I am planning to input an analog signal to AM3357's AIN by dividing the voltage. Was the constant of the voltage divider resistor OK with the constant shown in the figure? I am wondering if I should add…
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62x, AM62Ax, AM62Px, AM62D-Q1, AM64x, AM243x: OSPI Phy Tuning Algorithm

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: AM62A7 Other Parts Discussed in Thread: SYSCONFIG Tool/software: Questions addressed in this post: What is OSPI Phy Tuning? When is the Phy Tuning Algorithm used? Where is the Phy enabled and disabled throughout the MCU PLUS SDK…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM6442: Clock Specifications for SERDES0_REFCLK0N SERDES0_REFCLK0P and USB3

    TK0312
    TK0312
    Part Number: AM6442 Other Parts Discussed in Thread: SK-AM64B Tool/software: Hello, I am designing a board with Ethernet and USB3 using the AM6442. I have referred to the device sheet and TRM, but I could not find the required specifications for…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM6442: MCU_OSC0 Crystal Circuit Requirements

    Guillaume Henri
    Guillaume Henri
    Part Number: AM6442 Tool/software: Dear Sitara HW champs, In the Table “6-19. MCU_OSC0 Crystal Circuit Requirements” in the AM64x datasheet, it is specified the following : . When not using the RGMII and/or RMII interfaces, then +/-100 ppm Xtal…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: Data Verification Error while loading the program on M4F core

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Tool/software: I am trying to load the SDK example code to AM62x/AM64x board, but I am facing an issue while loading the program into it as shown in the below screenshot. Can you please help to resolve the above error…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197926 Discussions
  • Discussion

    HELP----"Invalid Module Format" error @ insmod V4L module for OMAP3530 Locked

    381 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Problem running CCS Locked

    245 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    Questions about libraries and test codes 0 Locked

    371 views
    2 replies
    Latest over 16 years ago
    by RobbySun
  • Not Answered

    Testing External Memory 0 Locked

    1965 views
    16 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Discussion

    dm355 busybox Locked

    354 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    do a menu including 1.encode 2. decode 3. stock up 4.encode and stock up 5 pause 6 quit the 7stop ? Locked

    225 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    may I encode and decode mpeg4 in dm355 IR remote ? Locked

    321 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    How to use a pipe to transfer data between two tasks?? 0 Locked

    236 views
    2 replies
    Latest over 16 years ago
    by wenying xu
  • Discussion

    Linux/Kernel -dispc_reg_merge() and dispc_reg_out() Locked

    286 views
    3 replies
    Latest over 16 years ago
    by Elric
  • Discussion

    DM355 running on battery. Locked

    340 views
    4 replies
    Latest over 16 years ago
    by viethoang
  • Not Answered

    NOR flash on DM355 0 Locked

    314 views
    5 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Introducing Delay in Program[CCS 3.3] Locked

    901 views
    5 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    How to boot the EVM6437 board with CCS? 0 Locked

    366 views
    3 replies
    Latest over 16 years ago
    by TimHarron
  • Not Answered

    Input video format question while using IMGLIB 0 Locked

    422 views
    3 replies
    Latest over 16 years ago
    by akira
  • Discussion

    data verification failed at 0x80000000.unable to access sdram Locked

    476 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Does lib file can be converted to ais file 0 Locked

    458 views
    5 replies
    Latest over 16 years ago
    by Geetha
  • Discussion

    TMS320C6000 DSP (CPU) and DMA Locked

    383 views
    4 replies
    Latest over 16 years ago
    by Camila Nunes
  • Discussion

    Connecting to DSP on OMAP3503 EVM Locked

    410 views
    5 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    DSP/BIOS newer than 5.31.02 update problem 0 Locked

    317 views
    0 replies
    Started over 16 years ago
    by vcar4195
  • Discussion

    Connecting to the Codec Engine of DM355 Locked

    331 views
    1 reply
    Latest over 16 years ago
    by BrandonAzbell
<>