Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM625
Tool/software:
Hi TI Experts,
I have a question about "Figure 7-16. MCU_OSC0 Start-up Time" from the datasheet. Here it looks like that MCU_OSC0 is only allowed to start when VDD_CORE is ramping. In reality the oscillation starts already…
Part Number: AM3357
Tool/software:
Hi team,
I am planning to input an analog signal to AM3357's AIN by dividing the voltage. Was the constant of the voltage divider resistor OK with the constant shown in the figure? I am wondering if I should add a…
Part Number: AM62A7 Other Parts Discussed in Thread: SYSCONFIG Tool/software: Questions addressed in this post:
What is OSPI Phy Tuning?
When is the Phy Tuning Algorithm used?
Where is the Phy enabled and disabled throughout the MCU PLUS SDK code offering…
Part Number: AM6442 Other Parts Discussed in Thread: SK-AM64B
Tool/software:
Hello,
I am designing a board with Ethernet and USB3 using the AM6442. I have referred to the device sheet and TRM, but I could not find the required specifications for the clock…
Part Number: AM6442
Tool/software:
Dear Sitara HW champs,
In the Table “6-19. MCU_OSC0 Crystal Circuit Requirements” in the AM64x datasheet, it is specified the following :
. When not using the RGMII and/or RMII interfaces, then +/-100 ppm…
Part Number: PROCESSOR-SDK-AM64X Tool/software: I am trying to load the SDK example code to AM62x/AM64x board, but I am facing an issue while loading the program into it as shown in the below screenshot.
Can you please help to resolve the above error…
Part Number: AM625 Other Parts Discussed in Thread: TMDS64EVM , SK-AM64B , SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP , , SK-AM62A-LP , AM62P , SK-AM62P-LP Tool/software: HI TI experts,
We are currently designing a custom board leveraging TI SK collaterals…
Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM
Tool/software:
Hi Expert,
My customer Motovis report an issue about ethernet link down issue, customer have catch the MDIO using the Logic analysis, they find there is some difference between…
Part Number: AM625
Tool/software:
Hi Ti Experts,
I am designing a custom board for the AM6254 SoC and trying to connect an SPI peripheral to the AM6254 SPI interface.
I intend to use MCU_SPI1 Channel but I am not sure which one is MISO and MOSI between…
I am using a processor with a DM R5F (AM62x, AM62Ax, AM62Px). I am using SDK 9.2.1 or SDK 10.0. The Device Manager (RM) R5F core is listed in the Linux devicetree, so Linux should use the remoteproc driver to attach to the DM R5F during Linux boot time…
