Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] TDA4VM: Large size of tispl.bin after integrating custom DM firmware for MCU R5

    Part Number: TDA4VM Other Parts Discussed in Thread: TI-CGT I have updated the Linux SDK top level Makefile to add my custom firmware for MCU1_0 (MCU R5). As I understand the path to the ELF image needs to be set as UBOOT_DM in the Makefile. But after…

  • [FAQ] TDA4VM: Not able to receive messages for a particular CAN ID, how to debug?

    Part Number: TDA4VM I am using MCAL CAN driver and able to transmit any message from the TDA4 using MCU MCAN0. However when I try to receive messages for a particular CAN ID from an external CAN emulator, I am not getting that on the TDA4's MCU MCAN0…

  • [FAQ] 66AK2E05: How to load and run the ARM gel file on K2E EVM

    Part Number: 66AK2E05 Hi, How to load and run the ARM gel file on K2E EVM ?

  • [FAQ] 66AK2E05: How to load and run the DSP gel file on K2E EVM

    Part Number: 66AK2E05 Hi, How to load and run the DSP gel file on K2E EVM?

  • [FAQ] 66AK2E05: How to create "Target configuration" and do "Test connection" on K2E EVM.

    Part Number: 66AK2E05 Hi, How to create "Target configuration" and do "Test connection" on K2E EVM?

  • [FAQ] TMS320C6657: How to load and run the DSP gel file on C6657 EVM

    Part Number: TMS320C6657 Hi How to load and run the DSP gel file on C6657 EVM ?

  • [FAQ] TMS320C6657: How to create "Target configuration" and do "Test connection" on C6657 EVM

    Part Number: TMS320C6657 Hi, How to create "Target configuration" and do "Test connection" on C6657 EVM ?

  • [FAQ] AM6254: Monitor pins

    Do the MON_1P8 3P3 ER_VSYS pins have a functional meaning or are these simply ADCs which can be read out by the CPUs for diagnostic purposes? Regards Bernd

  • [FAQ] TDA4VM: Porting a PDK Driver to an AUTOSAR Environment

    Part Number: TDA4VM I want to port an existing PDK driver into our AUTOSAR environment. How can we achieve this? For example, if we wish to port the I2C driver from the PDK, how would we go about doing this so we can include it in our project?

  • [FAQ] AM3359: How do I set up periodic interrupts using the timer?

    Part Number: AM3359 How can I set up periodic interrupts using the timer module on the AM335x SOC?

View FAQ threads
  • Threads 198506 Discussions