Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TDA4VM I am using a custom board with TDA4VM. Boot hang at A72 SPL with OSPI boot. Traces below:
U-Boot SPL 2019.01-dirty (Jan 21 2021 - 06:14:16 +0000) SYSFW ABI: 2.9 (firmware rev 0x0013 '19.12.1-v2019.12a (Terrific Lla') Reading on-board…
Part Number: AM6548 The R5 SPL is loaded onto OCMC RAM as the DDR is not up by the time R5 SPL executes. AM654x-EVM stops booting as soon as the tiboot3.bin size increase above 150KB size.
How to add more features?
Part Number: TDA4VM
I have the following questions:
How to know which driver is probed with a particular Device tree node?
How to know which CONFIG to be enabled to probe a particular Device tree node?
How to get the DTS(device tree source)…
Part Number: TDA4VM Other Parts Discussed in Thread: DRA829 ,
Hello:
From the datasheets,we know that CPSW9G supports TSN function.But we could not determine which MAC ports support TSN.Please porvide some detailed information.
In addtion,we find…
Other Parts Discussed in Thread: OMAP-L138 , OMAP-L132 , OMAP-L137 , OMAPL138 OMAP-L13x/C674x Resources and FAQ
How do I get started?
Software
Processor SDK for OMAPL138 Processors for Linux and TI-RTOS Support - Supported Devices: OMAP-L138, OMAP…
Part Number: AM6548 Linux SDK 7.1 fails on PG 1.0 board. No traces on UART seen. Sysfw does not seem to be loaded. How can i get Linux booted with SDK 7.1 on PG 1.0 AM65.
