TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197777 Discussions
  • Answered

    where can I get an XDCtool 3.20.8.88 installation for linux 0 Locked

    413 views
    1 reply
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Answered

    C6657 software environment 0 Locked

    524 views
    5 replies
    Latest over 10 years ago
    by Pubesh
  • Not Answered

    SPI init will affect INT1 status , CPU C5515 0 Locked

    1400 views
    10 replies
    Latest over 10 years ago
    by Vasantha K
  • Not Answered

    pandaboard run ubuntu 12.04 0 Locked

    1212 views
    3 replies
    Latest over 10 years ago
    by Yuan-Heng Lu
  • Not Answered

    Running OpenCL API on OMAP5432 0 Locked

    318 views
    0 replies
    Started over 10 years ago
    by REBEL SEQUEIRA1
  • Not Answered

    AM437x USB register 0 Locked

    826 views
    2 replies
    Latest over 10 years ago
    by Jian Wu1
  • Not Answered

    DM 8127 computer vision 0 Locked

    574 views
    2 replies
    Latest over 10 years ago
    by Hongfeng Wang
  • Not Answered

    TMS320VC549: problems with building code 0 Locked

    605 views
    2 replies
    Latest over 10 years ago
    by Steve Tsang
  • Not Answered

    USB reference manual for C5535 0 Locked

    640 views
    4 replies
    Latest over 10 years ago
    by David (ASIC) Liu
  • Answered

    Can AM335X GPMC Interface to 512MBytes NAND Flash ? 0 Locked

    2616 views
    4 replies
    Latest over 10 years ago
    by JJD
  • Answered

    aic3204.c and .h can anyone send me them? 0 Locked

    1549 views
    10 replies
    Latest over 10 years ago
    by Mark M
  • Answered

    DSP Link 1.65.01.06[dsplinkk.ko] on Linux kernel 3.13 0 Locked

    482 views
    2 replies
    Latest over 10 years ago
    by Vincent W.
  • Answered

    AM437X DSP engine 0 Locked

    586 views
    3 replies
    Latest over 10 years ago
    by Rogerio Almeida
  • Answered

    KeystoneII A15 instruction manual 0 Locked

    465 views
    1 reply
    Latest over 10 years ago
    by Raja
  • Not Answered

    Bootloading from MMC/SD card 0 Locked

    499 views
    2 replies
    Latest over 10 years ago
    by Sivaraj Kuppuraj
  • Not Answered

    Problem about clear dm8168 mcbsp SPCR1 RSYNC_ERR 0 Locked

    598 views
    4 replies
    Latest over 10 years ago
    by Xavier
  • Answered

    Encoder setting to give video slice output not working 0 Locked

    1950 views
    21 replies
    Latest over 10 years ago
    by Hareesh Das
  • Answered

    Unable to gst-launch 0 Locked

    582 views
    2 replies
    Latest over 10 years ago
    by Muhammad Salih
  • Answered

    RESETSTAT Timing in warm Reset 0 Locked

    1277 views
    6 replies
    Latest over 10 years ago
    by Bill Taboada
  • Discussion

    Character not displaying on GLCD -- DM8148 davinci processor Locked

    412 views
    1 reply
    Latest over 10 years ago
    by Pavel Botev
<>